Interesting Zenith problem
 

For those running Zeniths and also that have helped me over the years, I found an interesting problem with my Zeniths. After stripping down and soaking both banks for a week and reassembling, one bank was running great and the other rich. I stripped it down again and soaked but during reassembly noticed that while priming the accelerator pumps, the center accelerator jet would lift and flood the gasket with fuel. I guess the por had worn and even with a rebuild kit, there as too much slop. anyway once corrected the problem I ran great! I'm going to fit all my accel jets with a slightly fatter o-rings.