930 PP bolt pattern
 

Hello there!

I'll make it brief:
It's question regarding bolt pattern of 930 3.3 pressure plate. Does anyone know dimension "A"? Our measurments with steel ruler say it's 255mm but it's good to know for sure...Hayden maybe?

Thanx!

http://forums.pelicanparts.com/uploa...1072395113.gif

Not a single itty-bitty hint? :(

Merry Christmas Goran,

The PCD is 254 mm, the spacing is polar, 12 pattern minus 3 as you have illustrated.

I am one of the few who does not have a computer at my home,.....it's by choice! So Christmas was for eating, drinking and sleeping, not browsing.

Regards

Hayden

Merry Christmas Hayden!

Thanx for the info! It was very kind of you :-) I saw it was 12 minus 3 polar pattern by looking at it. It was obvious that there was 120 deg. spacing between "hole groups" and two periferic holes were aligned on horisontal plane which clearly indicated that they are 30 deg. apart. Whoever designed those holes liked symetry, good thing I didn't skip those geometry classes :-)

I hope you enjoy rest of holidays.

Regards