|
|
|
|
| Author |
|
|
Registered
|
melting distibutor rotors on my 72 911
Hi I'm Mark, I have a 72 911 2.4 litre, last year I put in an msd digital six ignition and msd coil, switched the points to electronic (the pertronics kit) and the engine has never run better, except that I am melting my distributor rotor. The epoxy resin that covers the windings in the rotor is melting and the rotor gets very hot. I have gone threw 2 or 3 in the last year. What do you think the problem could be? Any help would be greatly appreciated, thanks,
|
||
03-21-2004, 05:38 PM
|
|
|
Registered
Join Date: Apr 2001
Location: Linn County, Oregon
Posts: 48,527
|
I'm wondering if your dizzy might be "out of round"? Perhaps worn bushings? I'd say pull the dizzy, either inspect yourself or have a pro look it over. Also, how did you wire in the Pertronix?
__________________
"Now, to put a water-cooled engine in the rear and to have a radiator in the front, that's not very intelligent." -Ferry Porsche (PANO, Oct. '73) (I, Paul D. have loved this quote since 1973. It will remain as long as I post here.) |
||
|
03-21-2004, 05:57 PM
|
|
