|
|
|
|
| Author |
|
|
Guest
Posts: n/a
|
need #s info on my 915
i pulled my engine and trans this weekend. i noticed that my trans had been rebuilt which is a good thing as my car is a 73t. it looks like the case was painted black and new lock nuts were installed. a friend said that it looks like a good rebuild. i want to know if it is the original trans from my car. there are 3 sets of #s on 3 sections of the trans.
bell housing-915.301.101OR center-915.301.102.OR tail-901.301.301.OR i would appreciate all the info that you guys can give me. thanks! joe |
||
03-23-2004, 10:04 AM
|
|
|
Registered
Join Date: Feb 2000
Location: Dallas, TX
Posts: 4,612
|
Did you get the transmission #. It's stamped into the lowest part of the transmission.
__________________
Neil '73 911S targa |
||
|
03-23-2004, 10:12 AM
|
|
|
Registered
Join Date: May 2000
Location: Los Alamos, NM, USA
Posts: 6,044
|
Those are all casting numbers which don't tell one much. Look for the type and serial number stamped on the raised transverse flat surface on the very bottom near the drain plug. It is often defaced by wear as this can be a place that hits if the car goes over something like a speedbump or curb. Jim
|
||
|
03-23-2004, 10:12 AM
|
|
|
Guest
Posts: n/a
|
thanks guys. i will look.
joe |
||
|
03-23-2004, 10:23 AM
|
|
|
Guest
Posts: n/a
|
yes the #s were scrapped off! is there another way of finding out?
joe |
||
|
03-23-2004, 11:04 AM
|
|
