Borrow 36mm Oil Line Wrench in Richmond, VA?

PcarPhil · 02-15-2005, 05:10 AM

Does anyone in the Richmond area happen to have a 36mm oil line wrench that I could borrow until mine arrives from Pelican?

I need to drop my oil tank but I'm stuck until I get a wrench to try and get the oil lines off.

Please email me skaefer@yahoo.com if you can help out. Thanks!
-Kaefer

Rick Lee · Rick Lee's Garage

I can mail you mine tomorrow if you have time to wait. I'm done pulling my engines for a few more mos.

PcarPhil · 02-15-2005, 06:57 AM

Rick,

If it will only cost a buck or two to mail and it can be here before Saturday then SURE that would be great! Please email me and I'll send you my mailing info.

Thanks for the help,
-Kaefer

hkspwrsche · 02-15-2005, 07:10 AM

you could call robert at lufteknic and see if you could leave a deposit and borrow one of his?

scphelps1 · scphelps1's Garage

Your location says central, VA, are you in Richmond or on the west side? I have one you can borrow, but I'm closer to Cville than Richmond. You're welcome to borrow mine, if you can determine the best means of getting it (shipping or picking it up).

PcarPhil · 02-15-2005, 08:53 AM

Hmmm....options. I love this forum!

Rick is going to send me down his wrench to borrow. Thanks to Rick, hkspwrsche, and scphelps1 for the replies.

-Kaefer

PcarPhil · 02-27-2005, 05:05 PM

Rick,

I'll be sending your wrench back this week. Thanks again!
-Kaefer

Brother · 02-27-2005, 05:08 PM

I might need one as well.

I just read in "Gold Plated Porsche" that the damn thermostat strips out everytime you disconnect a line from it.

Is this the truth or can it be avoided? Can you get by without this wrench set?