Pelican Parts Forums

Pelican Parts Forums (http://forums.pelicanparts.com/)
-   Porsche 911 Technical Forum (http://forums.pelicanparts.com/porsche-911-technical-forum/)
-   -   Minnesota Engine Drop Get Together (http://forums.pelicanparts.com/porsche-911-technical-forum/258921-minnesota-engine-drop-get-together.html)

cyprusx 01-02-2006 06:41 PM

Minnesota Engine Drop Get Together
 
We are in the dead of winter and I decided to drop the engine for a major tuneup and cleanup. While the drop is not at all necessary, I am looking forward to doing it again.

I will host a little get together and you can participate, watch or just eat the food and drink the beer and chat with other pelicans. I enjoyed my last drop get together and look forward to this one.

Unfortunately, the notice is short. I will be dropping Saturday 1/7/06 at 10:00 am.

The garage is heated and all the prep work will be completed beforehand. The get together shouldn't last longer than 2-3 hours so it won't waste your whole day but will be nice to see everyone.

If you are interested, PM me and I will respond with directions.

85eurocarrera 01-03-2006 06:51 AM

Rick,

I really need to get to one of these as I would like to do one myself..........but, I will be out of town.

What type of lift are you using to lower the motor out with? I was looking to get a motorcycle/ RV lift but not sure how well it would work on my snowmobile. Looking at snowmobile lifts but not sure if it will work for the 911. Like to buy just one to do the sled and 911 but not sure if it is possible.

Thanks for the invite though!

Joe

cyprusx 01-03-2006 09:47 AM

I use a motorcycle jack with a beefed up furniture dolly for the engine. I use a long tonge jack to lift the car and roll the engine out. It works great... I will let you know when it goes back in, hopefully you can make it then to see...

Rick

cjf 01-03-2006 04:59 PM

I wish I could be there for the experience. Unfortunately I have to work Saturday :( Maybe when you get ready to put it back in I will have the the day off if the invite is still open.

cyprusx 01-04-2006 05:47 AM

Chuck, sounds good... I will let you know when its time to put it back in...

cjf 01-04-2006 06:35 AM

Rick, Will look forward to it if I'm lucky enough to have day off when you put the engine back in. Hope you have a great turn out for the drop. If you would like a little newbie help in prep for the actual day of drop, I might have an evening free to learn.
Chuck

PhatRedHead 01-04-2006 06:43 AM

cyprusx, you have a pm, i'd be down for helpin with this!!! pm sent!!!

Rikao4 01-04-2006 07:17 AM

To the lurkers here, you owe it to your Porsche and self to attend one of these. It really helps with your fear of the car, and do not forget those $$ you can save by doing some projects yourself.
I had a blast last year when Brother did his. Even if your a klutz, there is something you can do/ help with or hold, and you will understand how the parts relate/ connect better. The plus side, that when you go for it ..there are others who will come to your aid in return. You may disagree on the OT side, but during the drop you make friends that you can call when yours acts up, or fails to act at all.
Rika

cyprusx 01-04-2006 05:40 PM

Chuck: Prep is already completed. I did that last Sunday. I was almost going to drop it then but I wanted to host a little dropping party because the first one was very enjoyable.

Phat: Directions sent.

Rikao4: You are absolutely spot on in your previous post.

Tally so far:
1 - for sure
2 - maybe
1 - not likely but not entirely ruled out

cyprusx 01-04-2006 05:44 PM

She is ready and waiting!!!

http://forums.pelicanparts.com/uploa...1136425411.jpg

limble 01-04-2006 06:12 PM

Rick,
Count me in. I might have a california Pelican with me. PM me your address. Agreed that last one was fun. Just don't ask me how my rebuild is going.

Mike

cyprusx 01-04-2006 06:43 PM

Perfect...

Is your buddy the same one that you brought last time?

I promise not to ask about your rebuild progress. After all, you are only a couple of years into it... lol... patience is, well, waiting a long time...

RonDent 01-04-2006 07:17 PM

Hell yah I'm up for it! I'll get hold of Mike!

cyprusx 01-05-2006 06:48 AM

I look forward to meeting you Ron.... I must reiterate that we are in the dead of winter in the upper north so be prepared for the cold if you haven't truely experienced it before... If you have, never mind...

Having just returned from a two week vacation in Hawaii, I welcome the cold. I don't want to see the sun for a while... I can only take so much of the intense heat. Maybe because I was born and raised in the ice cube of the world... It is what it is.... heh

BGCarrera32 01-05-2006 07:08 AM

Rick I like your exit sign in case you forget where the door is...:D

RonDent 01-05-2006 07:51 AM

Rick,
I'm here in Bloomington now, and yes, I've been here before. And yes, it was January that time too. I like someone is trying to tell me something.

cyprusx 01-05-2006 06:01 PM

BG: Never can tell with some of us... lol

Ron: Great!! See you Saturday!!!

Tally so far:
5 - for sure
2 - maybe
1 - not likely but not entirely ruled out

Any more local lurkers on the bubble?

real550A 01-05-2006 06:49 PM

Rick-
Please PM directions, if you would. Nothing for sure, but if it fits, I'll be there. Thanks!

cyprusx 01-06-2006 06:56 PM

Tis the night before the drop party. See you all in the morning!!!

Tally:
6 - for sure
2 - maybe
1 - not likely but not entirely ruled out

Last chance for anyone on the bubble...

nabilious 01-06-2006 09:24 PM

Hey Rick - If you could pm me some directions....I'll be the guy that just pretends to have done it before! I'd be nice to see some of the faces!
Cheers,
Nabil


All times are GMT -8. The time now is 07:42 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website


DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.