|
|
|
|
| Author |
|
|
Registered
|
Wiring short nightmare
Did the wiper reversal project from Wayne's book. Everything seemed to go very well. Was careful to make sure wires didn't get involved when returning heater box to it's place. Put everything else back together.
Now the O2 light and the battery/alternator light both come on and stay on. Took out heater box again and don't see any pinched wires or anything pulled loose. Nothing seemed even close to the area where the box belongs. Any wiring schematic experts out there who can help me chase this down? Thanks.
__________________
1982 911SC 1987 924S Last edited by rbuswell; 05-30-2006 at 05:14 PM.. |
||
05-29-2006, 08:16 AM
|
|
|
Registered
|
Any nibbles?
Anyone have a theory why both the O2 light and the battery/alternator light would both come on after this project? I still haven't found anything loose or broken.
__________________
1982 911SC 1987 924S |
||
|
05-30-2006, 03:51 AM
|
|
|
Registered
|
I meant OXS light
Not sure why I said O2 light but I meant OXS light. Another note ... the car seems to start and run normally otherwise. Just the two lights come on and stay on. Bentley manual talks about the alternator light coming on and staying on when under high load, in other words when there is a short of some sort. Ideas of where to start looking?
__________________
1982 911SC 1987 924S |
||
|
05-30-2006, 05:12 PM
|
|
911 SC
924S
