![]() |
|
|
|
Registered
Join Date: May 2007
Location: Hawaii
Posts: 141
|
![]()
Howzit!
Identification please... lol I'm cleaning and preparing my engine compartment to install my heater block-off plate... As I'm wrapping up for the evening, I find this little plug (tip is rubber), tool, or something...(see photo below). I don't know if this even belongs to the car??? Interestingly I found it just sitting there on my open deck, near the latch hole... Does anyone have any idea what this is? Where it might come from? Thanks much, Tom ![]() ![]()
__________________
1978 - 911SC Targa 2005 - F150 2008 - XC90 Kaneohe, Hawaii ![]() |
||
![]() |
|
Registered
Join Date: Feb 2002
Location: Maple Ridge, BC, Canada
Posts: 984
|
It's a plug for the idle mixture screw access hole, located between the intake air rubber boot (above the flapper valve) and the fuel distributor head.
__________________
Al Shkuratoff 86 Carrera, SW chip, Fabspeed, M&K 83SC Platinum - Sold 83SC Slate Grey - Sold |
||
![]() |
|
sudo apt-get purge 930
Join Date: Jul 2006
Location: Brandon, FL
Posts: 4,838
|
Quote:
__________________
Mark 1979 930 Euro ***GONE AND DON'T MISS IT AT ALL*** "Worrying about depreciation on your car and keeping mileage down is like not ****ing your girlfriend so her next boyfriend finds her more appealing" --clutch-monkey |
||
![]() |
|
Registered
Join Date: May 2007
Location: Hawaii
Posts: 141
|
Quote:
Thanks so much! Mahalo! Tom ![]()
__________________
1978 - 911SC Targa 2005 - F150 2008 - XC90 Kaneohe, Hawaii ![]() |
||
![]() |
|