![]() |
|
|
|
Registered
Join Date: Sep 2004
Location: Tacoma, WA
Posts: 16,541
|
Issue with old seats
I have a 79 with non-sport seats. The drivers side this am did not seem to want to hold its setting after adjusting the incline with the wheel. Every time I got it to where it felt right soon after it was back to where I started.
I this the begining of the end of these seats and is it dangerous?
__________________
David I don't suffer from insanity, I enjoy it. '79SC Targa '2021 CRV Last edited by Porsche-poor; 07-27-2007 at 09:47 AM.. |
||
![]() |
|
cycling has-been
Join Date: Sep 2004
Location: Jersey Shore
Posts: 7,238
|
yes, and yes
I don't think this is an easy fix. All the gears and cogs are burried inside the seat-back upholstery. But, the entire seat, or just the backs, will swap left - right - if you don't mind reaching around to the center of the car to pull the back release. If you do the entire swap, you can leave as-is , in which case the slide release will be on the outboard side, or keep the sliders on their original side by transferring to the opposite seat. Bill K
__________________
73 911T MFI, 76 912E, 77 Turbo Carrera |
||
![]() |
|
Evil Genius
|
you can also buy my race seats that I just put up for sale on the classifieds section and you're local so it'd be close for you to have new seats that hold their position!
Race Seats for sale - cheap!
__________________
Life is a big ocean to swim in. Wag more, bark less. ![]() |
||
![]() |
|
Registered
Join Date: Sep 2004
Location: Tacoma, WA
Posts: 16,541
|
bkreigsr, thanks for the heads up. Was just about to have them recovered, probably not now.
Thanks Rusty but I would have the same height issue.
__________________
David I don't suffer from insanity, I enjoy it. '79SC Targa '2021 CRV |
||
![]() |
|
cycling has-been
Join Date: Sep 2004
Location: Jersey Shore
Posts: 7,238
|
David, if you are going to re-upholster any how, all the guts will be exposed and its just a matter of shimming the gears closer to each other, or maybe replacing a wayward cir-clip retainer.
I think Bill K
__________________
73 911T MFI, 76 912E, 77 Turbo Carrera Last edited by bkreigsr; 07-27-2007 at 10:04 AM.. |
||
![]() |
|
Registered
Join Date: Sep 2004
Location: Tacoma, WA
Posts: 16,541
|
I'll have to look into that. I'd have to be sure that its not going to break before spending the money to recover the seats.
Thanks.
__________________
David I don't suffer from insanity, I enjoy it. '79SC Targa '2021 CRV |
||
![]() |
|
![]() |