![]() |
Heat Exchangers & Race Headers
Does anyone know where we can source some 911 heat exchangers (SSI-type, pre-1974) with the primaries sized at 1 5/8 inches, rather than 1 1/2 inch? Flowbench work suggests this can help top-end power with the cams we run. Many thanks for anyone who can help..............
|
Bob Holcombe owner of Mode would be a good place to start also check with Marco Manzie of Billet Design.
|
We have some custom-made 1 5/8" GHL HE's with OEM flange spacing that works very well for such applications.
|
All times are GMT -8. The time now is 12:02 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website