|
|
|
|
| Author |
|
|
Registered
|
930 brake banjo fitting
Can anybody tell me the thread size on the large hard line to caliper fitting for a 930 turbo caliper and if there is an alternative one piece unit available
Thanks Andy 
__________________
www.facebook.com/pages/Bournville-Frameworks |
||
05-10-2010, 03:00 AM
|
|
|
Registered
|
M10x1 all of them (feed line, brigde and hollow screw)
__________________
Roland 930 Turbo '81 Too many modifications to list |
||
|
05-10-2010, 03:49 AM
|
|
|
Registered
|
thanks PF the start of the thread is dodgy on mine I need a longer one or a slimmer tee piece if that makes sense.Anybody know of an alternative supplier ?
__________________
www.facebook.com/pages/Bournville-Frameworks |
||
|
05-10-2010, 04:10 AM
|
|
|
Registered
|
Slimmer would be heavy to find, but you can change the angle of the banjo as you like and make a custom feed line then
2nd: You can move the banjo to the outer half of caliper, if there is enough clearance to the wheel
__________________
Roland 930 Turbo '81 Too many modifications to list Last edited by proffighter; 05-10-2010 at 05:10 AM.. Reason: addition |
||
|
05-10-2010, 05:07 AM
|
|
The Ark
