|
|
|
|
| Author |
|
|
1970 911 T
|
accelerator linkage
Cant seem to get my pedal to do full travel........... How do I adjust ?
My car is a 1970 911 with webers. What is the procedure to make the adjustment so I can get full power when I depress the pedal. Actually the pedal only travels about half way! Thanks Frank |
||
07-16-2010, 04:28 AM
|
|
|
Registered
|
Check the bushings in the bell crank located in the engine compartment. OEM bushings are nylon and deteriorate over time causing the linkage arms to twist and not give full throttle. I recently replaced mine with brass bushings and made a big difference in throttle response and throw.
__________________
Fred 76 911s WB 3.0L 72 Int. Scout II 06 Mustang GT "Limping in the right direction is always faster than running the wrong way" |
||
|
07-16-2010, 07:36 PM
|
|
|
Registered
|
Whoops, just noticed you have a earlier model with carbs, so my advice for a 3.0L CIS may not apply.
__________________
Fred 76 911s WB 3.0L 72 Int. Scout II 06 Mustang GT "Limping in the right direction is always faster than running the wrong way" |
||
|
07-16-2010, 07:38 PM
|
|
Jezebel
Brownie
1973 Porsche 914 2.0
1976 Porsche 911S 3.0L
911 Carrera Coupe
