Pelican Parts Forums
Page 2 of 2 « Prev 1 2
Show 40 post(s) from this thread on one page

Pelican Parts Forums (http://forums.pelicanparts.com/)
-   Porsche 911 Technical Forum (http://forums.pelicanparts.com/porsche-911-technical-forum/)
-   -   need to bend a steering arm, will MAPP torch suffice? (http://forums.pelicanparts.com/porsche-911-technical-forum/585133-need-bend-steering-arm-will-mapp-torch-suffice.html)

chris_seven 01-14-2011 08:59 AM
Doug,

I would think around 600 deg C would be enough.

Good Luck

DW SD 01-14-2011 09:19 AM
Chris,
Should the part be air-cooled following the heat treating processes? Not quenched in any way, right?

Doug

Flieger 01-14-2011 09:23 AM
Judging from his previous post, I suspect just letting it cool naturally is best. No water.


All times are GMT -8. The time now is 02:10 AM.
Page 2 of 2 « Prev 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website


DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.