![]() |
Pertronix Ignitor not working with MSD 6A
I bought an Ignitor Electronic Ignition (2862), on Pelican Parts Site to install on my Porsche 911T (year:1969).
My car has a MSD 6A ignition kit installed (installation scheme attached). http://forums.pelicanparts.com/uploa...1315861741.gif After reading your instructions manual (attached also) I installed it putting: 1. Ignitor black wire to original distributor green wire (that goes through MSD to Coil Negative) 2. Ignitor Red Wire Directly to Coil Positive http://forums.pelicanparts.com/uploa...1315861777.gif … and the motor do not run. I try other several ways and nothing! I take out the ignitor and put back the points and it is all ok again. What should I do? Regards, Carlos Domingos Portugal (Europe) |
seeing the drawings again...
I will try: - Pertronix Ignitor Black wire >>> original Green wire > MSD White Wire - Pertronix Ignitor Red wire >>>MSD Red wire |
All times are GMT -8. The time now is 11:37 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website