964Camshaft holding tool- used or rent?

[mmasse]

I nedd a 964 camshaft holding tool. It is the tool that allow to hold the sprocket while you adjust the camshaft nut.

Anybody willing to rent or sell used? I would like to avoid having to buy it new for a one time use.

Thanks

[mmasse]

morning bump.

[hcoles]

try borrowing from a friendly Pelican, suggested compensation is high quality beer

[mmasse]

Well didn't want to go that far.. But free is always better!! :-)

[Chuck.H]

Is the 964 tool the same as the earlier one? I only see one listed in pelican, and it says 80-89.

Chuck.H
'89 TurboLookTarga, 332k miles

[mmasse]

Hi Chuck

This is the tool I need. It seems that it cover from 80-94


Cheers...

[boyt911sc]

Mario,

If you still need to borrow a cam tool for your rebuild I could lend you one. I was borrowing tools before from other people (members) but once I got into serious engine rebuilding (multiple rebuilding projects) I decided to get my own tools. Lost one good set (exhaust stud kit) and never got it back and since then, learned from that experience.

An appropriate deposit (more than enough the cost to buy a replacement unit was the key) and the return were fast and punctual. But for people I personally know or recommended by a friend, no need for a deposit.

These tools are NOT for sale and need them back:

engine yoke (3)
engine stand (3)
cam tools (46-mm crow foot to 964 cams)
oil lines tools (assorted sizes)
exhaust stud kit tool (built by Christian)
engine hoist (pick-up only)

PM me for details.

Tony

[mmasse]

Hi Tony

That's great. At this point I only need the cam holding tool. If you can provide that one I am more than willing to give you a deposit. Please, PM with you info and Amount and I will sent the payment. Would you take Paypal?

I will PM you with my address

THANKS