Pelican Parts Forums

Pelican Parts Forums (http://forums.pelicanparts.com/)
-   Porsche 911 Technical Forum (http://forums.pelicanparts.com/porsche-911-technical-forum/)
-   -   Can anyone please check a section measure for me on SWB chassis? (http://forums.pelicanparts.com/porsche-911-technical-forum/686931-can-anyone-please-check-section-measure-me-swb-chassis.html)

AlexJ 07-03-2012 06:46 AM

Can anyone please check a section measure for me on SWB chassis?
 
Hi everyone,

Can anyone check the measure marked on the photo below - I know this photo is not from a SWB chassis but it is just to show which measure I am talking about:

Outter surface of the rear lower edge of the arch, to the chassis section right in front that edge - perpendicular to the chassis.

On the diagram, the yellow section.

Sorry my bad English, but I think the photo and diagram shows it all...

http://forums.pelicanparts.com/uploa...1341326667.jpg

Yellow marked section on the diagram bellow.

http://forums.pelicanparts.com/uploa...1341326771.jpg

keith28 07-04-2012 06:08 AM

Alex I have measured the points you have requested as I understand it and have 260mm from the vertical pinchweld flange out to the outside of the rear lower edge of the wheel arch on my 1966 SWB Karmann built 912.I hope this is of help to you.

AlexJ 07-05-2012 03:35 AM

Thank you very much for your help!


All times are GMT -8. The time now is 05:08 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website


DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.