|
|
|
|
| Author |
|
|
Registered
|
Ignition wires
While I have everything out/apart, I am going to do some basics.
I have a new distributor cap, rotor, plugs and I am going to order a wire set. The car had Beru, but I have been leaning towards the Clewett's. Any suggestions/recommendations on sticking with Beru or going with Clewett or Magnecor? Thanks in advance.
__________________
Every cloud has a silver lining (except for the mushroom shaped ones, which have a lining of Iridium and Strontium 90) 08 Cayman, 88 911 Targa, 93 MR2 Turbo, 2012 Jeep JK |
||
12-05-2012, 08:16 PM
|
|
|
Member 911 Anonymous
|
I have the Magencors but their dust covers do not hold up in the heat. I swapped them with the old set of OEM Beru dust covers. No problems now.
__________________
'85 Carrera Targa Factory Marble Grey/Black * Turbo Tail * 930 Steering Wheel* Sport Seats * 17" Fuchs (r) * 3.4 * 964 Cams * 915 * LSD * Factory SS * Turbo Tie Rods * Bilsteins * Euro Pre-Muff * SW Chip on 4K DME * NGK * Sienes GSK * Targa Body Brace PCA/POC |
||
|
12-05-2012, 08:24 PM
|
|
|
Registered
|
Thanks for the suggestion Draco.
__________________
Every cloud has a silver lining (except for the mushroom shaped ones, which have a lining of Iridium and Strontium 90) 08 Cayman, 88 911 Targa, 93 MR2 Turbo, 2012 Jeep JK |
||
|
12-05-2012, 08:28 PM
|
|
 |
| Thread Tools | |
| Rate This Thread | |
|
|
Ruby
Cosmos
Kitt
Marble Grey
