plumb4u2 |
03-19-2013 01:57 PM |
AEM Wideband o2 install?
I just received my AEM wideband that Bisi is selling in the classified section and I have a couple questions while I prepare for install
I have searched but no thread really spells out the install
I understand most everything except where the 0-5v output gets connected to? I think this gets connected where the old o2 sensor connected in the engine bay under fuel filter but I want to make sure before I screw something up?
If I understand it correctly the 0-5v output is basically giving the DME the signals from o2?
|