SC Ignition Distributor parts diagram Wanted

[LM3929]

I am looking for a complete parts diagram of the break down of a 80 to 83 3.0 liter SC distributor

I have two extra red fiber washers/bushing and can't remember where they go

Lorne M.

[HaroldMHedge]

Page 3 of this TSB explains where the bushings go.

Originally Posted by HaroldMHedge

TSB 78-04 lists an axial limit of 0.2 +/- 0.1 mm.

TSB 78-04







The Distributor Repair Kit, 1-237-010-007-INT, has the shims that are needed to rebuild a distributor but you need two of them to get two fiber (phelonic) washers.

83 SC Ignition Distributor Bushing Replacement has a good procedure on rebuilding the distributor.

[Trackrash]

hope this helps.

[HaroldMHedge]

Sorry for 2 posts. But, I'm working from my phone.

A Diagram is in this thread which shows most of the parts (except the washers).

Distributor service (Clean and lube) real easy without removing the pinion gear!

[LM3929]

Thanks, but I think those are the larger flat washers for the shaft, the ones that I am looking for are only about 5/16" in diameter

Lorne M.

[LM3929]

Found out where the red grommets go, too easy

Lorne M.