Early 911 Periscope washer nozzles

[tobey2]

Hi all.
I am new to this forum so I am not sure if this is the correct place to post this.
A few years ago I removed my front bumper on my 78 SC and fitted a replacement bumper without any headlight washer nozzles on it as I prefer the look of a plain bumper.
I stored the bumper, along with the large periscope type washers, rubber gaskets and clips in my garage as I had no need of it.
Recently a friend of mine said that someone on this forum was looking for a pair of these washers for their car so I thought I would join the forum, I have been meaning to join for a long time anyway, and see if I could find out who wanted them. So if the person who wanted them reads this then please get in touch.

There are the two washer nozzles, both rubber base gaskets and the two retaining clips. All of the parts are in excellent condition with no damage to any of them.

I am not too sure what price to ask but they are only plastic and rubber so probably not much at all. possibly only a few ££s

Thanks
Tobey

[Jabberwocky]

PM sent

[André 3.0]

100 euro��

[Cooper911SC]

Those are hard to come by now! = Valuable parts. $$$

[Shaun @ Tru6]

these are very valuable.

[tobey2]

Thanks for the replies.
I was told that I have placed this in the wrong section and it should have gone in the parts for sale section so I have placed the same thread there.
I did not know that these were valuable at all. Are they rare parts then?

Are they worth more than the 100 euro that Andre 3.0 has offered?

[André 3.0]

Mutch more.

[sp_cs]

Porsche 911 '74 -'78 Headlamp, Headlight Washer Jets, Nozzles | eBay

[tobey2]

Thanks for all of the replies, and over 45 PMs so far. I now have a much better understanding of what these early periscope washer jets are worth even though a few certain people would have me believe otherwise.
I still have them and will be deciding what to do with them over the next day or so.

[DCinVA]

Holy cr@p, 720 euro's.

[André 3.0]

720 GBP=870 EURO=1180 USD...............W.T.F.

3D printing is an option ??

[sp_cs]

I was thinking the same re 3d printing!