Holes in Fuchs Center Caps - For 'Crests?'

[RFP]

Happy Saturday!

Are these two holes in my Fuchs center caps for affixing 'crests?' so, which crests... part number or description or source... anything.

Thank you!

Rob

[Jerome74911S]

A tool with prongs that fit into those holes is used to pull the cap off of the wheel.

[Joe Bob]

Up until the holes were invented the caps came off when the wheels were off the car. Usually with a large wooden dowel or the ass end of a hammer with a sharp bang with a metric crescent wrench.

[RFP]

Originally Posted by Jerome74911S

A tool with prongs that fit into those holes is used to pull the cap off of the wheel.

Originally Posted by Joe Bob

Up until the holes were invented the caps came off when the wheels were off the car. Usually with a large wooden dowel or the ass end of a hammer with a sharp bang with a metric crescent wrench.

Many thanks... as you can tell, my Porsche knowledge is pretty dismal... thirty years between Porches is just way too darned long.

But, I am so loving this new (1987) car... today, I just set up my lawn chair in the garage, plugged in a box fan and just sat there with the car being grateful... My wife thinks that's pretty cool, but I'm afraid that I just may be nutz!

Thanks for the info!

Rob

[porschenut]

Originally Posted by Joe Bob

Usually with a large wooden dowel or the ass end of a hammer with a sharp bang with a metric crescent wrench.

I've used an SAE crescent with good results as well.

[Joe Bob]

Pinky lift included?