Does Anybody know where can I find it?
 

Dear Friends

I´m rebuilding this 1976 911 coupe that i recently purchase,
And I need to replace my CV boot, but my CV flange is not the stamped metal where the boot is clamped over it
My flange is a very thick solid metal probably 5mm in thickness and the boot is installed inside the flange
Any ideas where i can find the boot to buy and replace or worst case scenario the whole flange with the boot already inserted?
I think pelican don´t carry them

Thanks

Ricardohttp://forums.pelicanparts.com/uploa...1447284181.jpg
http://forums.pelicanparts.com/uploa...1447284216.jpg

Try Eric at www.pmbperformance.com

I wonder if that old part is aftermarket? Pelican has the flange and boot together ($13 for aftermarket): Porsche 911 (1974-1989) - Axles, Bearings & Differential - Page 2

Mark

It´s an old part the car is 76 and this one on the pelican is different, is the stamped type

That is an original style flange.

Just buy the complete boot/flange assembly. Pelican has them. EMPI or GKN/Lobro should be fine, though they're not quite as nice as the originals.

This should be it:
Pelican Parts - Product Information: 923-332-037-00-INT

Nope, this one is the stamped tin, with the boot clamped over, mine is different