|
|
|
|
| Author |
|
|
Registered
Join Date: Jun 2004
Location: Puerto Rico
Posts: 317
|
73 RSR DP Motorsports Backdate Rear Bumper
I have seen these backdate bumpers from DP motorsports that incorporate a lower rear valance in the design. Is there an similar bumper used here or available. I need the lower side valance to keep my AC condenser in place.
 
__________________
79 SC Back to Basics! 2006 997 C2s Cabrio - Sold 1999 996 C2 - Sold Last edited by ivanuf; 05-24-2017 at 03:30 PM.. |
||
05-24-2017, 06:26 AM
|
|
|
Registered
|
I saw somewhere that a guys did hard A/C lines down one side of the car to mimic the look of the oil likes not eh other side of the car. Liked good on his long hood hot rod. Just a thought.
__________________
Chris - Insta @chrisjbolton 1975 911s Insta: @911ratrod steel wide body, 3.6 conversion 1989 911 Carrera 25th Anniversary Ed (5th from the last car to ever leave the original Porsche factory assembly line) 2001 996 Turbo - ~54k miles |
||
|
05-24-2017, 11:16 AM
|
|
|
Registered
Join Date: Jun 2004
Location: Puerto Rico
Posts: 317
|
Good tip, but I am looking for a rear bumper that ends low on the side when it meets the tire. I hace a A/C condenser behind the rear driver wheel inside the rear fender that I will like to keep after the conversion
__________________
79 SC Back to Basics! 2006 997 C2s Cabrio - Sold 1999 996 C2 - Sold |
||
|
05-24-2017, 02:00 PM
|
|
|
Registered
Join Date: Jun 2004
Location: Puerto Rico
Posts: 317
|
No one has seen this available from the US vendors?
__________________
79 SC Back to Basics! 2006 997 C2s Cabrio - Sold 1999 996 C2 - Sold |
||
|
05-25-2017, 12:17 PM
|
|
911S Rat Rod
Anni
BatTurbo
