Is this hub and spindle toast?

[Jim D.]

Hi All,
Just wanted to tap the experience of the group and see if you think these are salvageable. Have a lateral run out on the front hub and pulling it I noticed a gouge and a protrusion near the inner bearing. The spindle has a few lines on it.
I thought a machine shop might be able to do something. What do you guys thing?
Thanks in advance,
Jim
1977 911s Targa

[911obgyn]

Hub is OK unless race spins, spindle needs measuring with a pair of calipers and measure the bearing inner race, if its within a few thou it should be OK. it looks like someone in the past used a large screwdriver to seat the bearing race. It doesnt look like the seal area is scratched and if it was i would use some non hardening sealant on it.

[Techno Duck]

No issue. Use emory cloth and smooth it out.

[Jim D.]

Hey Thanks,
I'll measure and try some emory paper. My budget would be stretched to replace them.
Jim

[DanielDudley]

Locktite makes products that would enable you to use that spindle.

[Jim D.]

What loctite product would that be?
Jim