TOB Guide Tube hardware
 

Well, again I come to the forum with a tranny question:

What hardware (length/pitch/head/washers/etc.) holds the TOB guide tube on a G50? I've got the tube on the way from Pelican but the hardware was going to take too long to get so I have to look local (and get my car back on the road this weekend)!

Figuring I'm probably going to do a bit of damage to the phillips heads during removal I'd like to replace with new but don't have the option of removing first to check sizes (car is in the mtns relatively far from any good harware stores).

Can anyone help me out?

Thanks folks! See you on the road Monday!

Todd,

You need only two screws and that's it.

They're countersink head screws with standard M6 thread by 14mm length (M6x14)

Perfect! Just in time. Kev, I owe you a beer or four. Thanks!

Cheers!