Conversion from 914-6

[HKZ Bob]

Dear Forum,

I am working on a project to integrate a 6 cylinder into a 914-4 harness.

I am looking for Photos of the original 914-6.

Specially:

Where was the CDI positioned?
Where was the alternator regulator was positioned?

Who has diagramm of the 914-4 Control Board.
I am interesting in the physical pin output and like to match it with the 911 engine harness.

I would like to use the experience on existing knowlage and not go though all problems too.

Regards
Merry Chistmas 2010

[HKZ Bob]

[HKZ Bob]

I am getting closer,

Who did this conversion already.
I the schematic correct? I guess not.
I need the connector endview of an 1971 911 2.2 engine

[larrym]

best thing you can do for yourself is to is buy Art zapf's 914-6 color wiring diagram

The Search is over! 914/6 Wiring Diagram

or for $10, I will sell you Art's earlier b/w 2-part diagram with color codes listed

one caveat - I have found that the wire colors on various years & models is not consistent, so expect to do some end-to-end tracing no matter what diagrams you capture

[Cairo94507]

I do not believe Art's color schematics are available any more. I tried several times to buy one from him and never was able. I think Art just stopped making them. If he ever did another run I would buy one for my garage wall.

I ultimately bought one from Jeff Bowlesby and have that one which I consider priceless.

[HKZ Bob]

Hi Happy new year, 2011

my intent of this thread was more to see how other people placed the CDI and
what is tricky on the conversion

Photos will be good of original 914-6

Please share date.
I have the schematic already which I need.

BR

[Jared at Pelican Parts]

this may help

[HKZ Bob]

Jared thank you,

Can you dive with your camera in the engine compartment and picture

the electric board, fuel pump, you are using a permature, and everything what need to be seen.

BR
Bob

Geil

[larrym]

Art is producing the diagram again - one sheet, all color - Zapf Enterprises

[racer]

jared.. where's your battery doh!

[quicksix]

Hey Bob,
try over on the 914 world board,in the originality section.
Lots of stock/factory engine bays
John