|
|
|
|
| Author |
|
|
Bobmspeedster
|
help with 916-6 rear valance
Working on my 1970 914-6. I have found a correct rear valance that someone has
altered to accept some type of dual exhaust. The area where the exhaust hole should be has been opened up with a large square hole. It is repairable but I need to know the correct place for the exhaust hole. Can someone with the correct valance take photo's make a template or take good measurements so that I can place the new hole in the proper place. Thanks in advance for any assistance Bob bobmspeedster@yahoo.com |
||
01-20-2016, 07:05 AM
|
|
