|
|
|
|
| Author |
|
|
Registered
|
Rod bearings replacement
Hi all, I’m replacing the rod bearings on the 944, parts ordered from this site and I have a question on the replacement bearings.
There are two types of bearings available on this site, both from glyco with the following part numbers. 928-103-143-15-4CYL-M4 944-143-02-INT I ordered one of each thinking they were meant for top and bottom but of course they are the same and one box is all I need. Any preference which set I should use?
__________________
1971 911T 1985 944 manual road car 1983 944 race spec car 2009 997.2 Carrera PDK) gone but not forgotten) 1988 Carrera Targa Euro Spec (gone by not forgotten) Last edited by BHP231; 08-21-2020 at 01:22 AM.. |
||
08-21-2020, 01:05 AM
|
|
|
Northern Motorhead
|
I built my race engine with the 928-103-143-15-AM rod bearings ... it's an 86 block with standard crank dimensions.
That is the P/N Lindsey Racing sells for N/A 2.5 engines !
__________________
Cheers Phil 89 Coupe,Black,95 3.6 engine and the list goes on ... 1983 944 SP2 race car PCA #96 |
||
|
08-21-2020, 04:22 AM
|
|
|
Antipurist
Join Date: Dec 2018
Location: Michigan
Posts: 59
|
I'm going with these over Glyco https://944store.com/product/82-91-porsche-944-951-968-standard-performance-rod-bearing-set/
|
||
|
08-21-2020, 05:04 AM
|
|
|
Registered
Join Date: Feb 2009
Location: Park Hills, KY
Posts: 2,459
|
I used the Porsche rod bearings from LR for my rebuild. just got it fired up a couple days ago.
__________________
Bob Cox 78 930 clone project car. 87 924S resurrect at some point. 84 928S, Ruby Red linen/brown interior - sold  86 944 turbo my new DE/track car - sold
|
||
|
08-21-2020, 08:01 AM
|
|
Alas no more
Alas no more
Project car - sold!
Gone but not forgotten
Race car - rolled it too many times
1987 Porsche 944 Turbo
Drove it - sold it
