964 Fog light lens

[Noah930]

Silly question, but looking at the parts catalog here and a couple other sites: for a 1990 964, is it possible to purchase just the fog light lens? Just the (clear) glass, not the entire assembly? (I have a cracked right-sided one.)

[964TargaC2]

I believe I have seen them listed on fleabay and the like, dont know if they are correct or not but it looks like it would be a bit difficult to get the lens off of the reflector without damage to the reflector, etc

[Ralph3.]

Yes, I have replaced both of mine. Purchased new lenses from Rose Passion, one lense was broken other had chips.

[heliolps2]

Yay. got one from Ebay. good price. Shipped from overseas quickly

[Ralph3.]

I did both because the new lenses looked great compared to the original sandblasted ones.

[Porschekalle]

yes, easy swap as well.

[Noah930]

Thanks to all. The part I'm looking for is the foglight lens "trim"--the piece of glass on the front bumper cap in front of the actual fog lamp itself. Looking at the parts fiche, I couldn't figure out the part number. But the eBay suggestion led me to find out it's 964-631-204-75. So now I can plug that into Pelican or any dealer webpage and place the order.

[Ralph3.]

Don't think that's what you want. Try Bosch pn's 1305621257 or 1305621258 depending upon side.

[porsche gt3]

Ralph 3
I purchased the lenses, but haven’t replaced them yet. Please let me know how you removed them and what glue did you use to re-install.
Thanks

[Ralph3.]

One of mine was shattered but the other side was intact and required careful removal. Once you get the lenses out of housing clean the channel that they set in and bond them back with a bead of a good indoor/outdoor silicone adhesive.

I found this thread helpful

https://rennlist.com/forums/964-forum/979423-cracked-fog-light-repair.html

[993buyer]

Hi guys,
I have purchased the fog lenses and want to install these in my 964, however, the glass fog light lens does not want to get out of the plastic frame. Perhaps it was replaced previously and a different sealant was used? How do I get the glass lens out of the plastic frame? Use a hammer and knock the glass lens out? Any suggestions appreciated! Thx.