Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums


Showing results 1 to 25 of 66
Search took 0.02 seconds.
Search: Posts Made By: halbl
Forum: Porsche 914 Used Parts For Sale & Wanted 06-09-2000, 03:33 PM
Replies: 10
Views: 504
Posted By halbl
I am looking fot good chrome front bumper,...

I am looking fot good chrome front bumper, running light grills, and a driver side door without the DOT beams (70-72) Thanks, Hal.
Forum: Porsche 914 & 914-6 Technical Forum 12-17-1999, 03:14 AM
Replies: 9
Views: 602
Posted By halbl
I mounted the coil in the engine compartment...

I mounted the coil in the engine compartment under the trunk springs because the coil wire should not be too long. The rest was put in the trunk out of the way under the front of the targa top...
Forum: Porsche 914 & 914-6 Technical Forum 12-12-1999, 06:39 AM
Replies: 11
Views: 1,020
Posted By halbl
Mark, are you saying the MSD dizzy is a bolt on...

Mark, are you saying the MSD dizzy is a bolt on option for the Crane HI 6 system if the plug wires are switched out? Hope so. I used MSD wires with the Crane system but do not trust the electronic...
Forum: Porsche 912 Technical Forum 12-08-1999, 06:30 PM
Replies: 11
Views: 1,145
Posted By halbl
This is often discussed on the 914 site. If...

This is often discussed on the 914 site. If everything checks out I would get a rebuilt Bosch starter, on of the big ones. I had the same problem and the replacement fixed it. The Bosch part number...
Forum: Porsche 914 & 914-6 Technical Forum 12-06-1999, 06:47 PM
Replies: 3
Views: 506
Posted By halbl
I put an 84 Carrera front on as bolt-on all the...

I put an 84 Carrera front on as bolt-on all the way. Only thing I had to change was the steering rod out of the rack. Comparing the two racks It looks like the 911 rack has built in bump steer.
Forum: Porsche 914 & 914-6 Technical Forum 12-05-1999, 10:00 AM
Replies: 8
Views: 734
Posted By halbl
JP, Dave: I found a 1981 Chilton's about VW's...

JP, Dave: I found a 1981 Chilton's about VW's but it has a section on the type IV rebuild. How does it compart to Haynes, Wilson, etc. Have'nt heard it mentioned before. Hal
Forum: Porsche 914 & 914-6 Technical Forum 11-29-1999, 02:08 PM
Replies: 4
Views: 488
Posted By halbl
Conrad, you are leaking somewhere. I would have...

Conrad, you are leaking somewhere. I would have an installer re-set it. They use a 1/4 inch bead of sealer. BE SURE TO REPLACE THE PLASTIC PINS FOR REATTACHING THE CHROME TRIM, BEFORE THE GLASS IS...
Forum: Porsche 914 & 914-6 Technical Forum 11-21-1999, 06:37 PM
Replies: 5
Views: 510
Posted By halbl
I heard somewhere the 912E 2.0L heads had 4...

I heard somewhere the 912E 2.0L heads had 4 bolts. Anyone know for sure? What compression was the 912E? How do these heads compare to 914 heads? Thanks.
Forum: Porsche 914 & 914-6 Technical Forum 11-11-1999, 06:21 PM
Replies: 10
Views: 933
Posted By halbl
This is odd but I think the heater fan blower in...

This is odd but I think the heater fan blower in the engine compartment and the fuel pump are on the same circuit. Does that fan come on? If not suspect the common fuse.
Forum: Porsche 914 & 914-6 Technical Forum 11-08-1999, 07:42 PM
Replies: 47
Views: 1,135
Posted By halbl
It is not unusual for police to over charge for a...

It is not unusual for police to over charge for a traffic stop, i.e., several charges , some redundant, such as : speeding (3-6 points); wreckless driving (6 points); wreckful driving (what that is...
Forum: Porsche 914 & 914-6 Technical Forum 11-07-1999, 05:15 PM
Replies: 7
Views: 557
Posted By halbl
The salvage title route of insurance companies...

The salvage title route of insurance companies with respect property taken in the claims process is the practice in my region (KY, IN, OH). Insurance companies seem to think this is the best way to...
Forum: Porsche 914 & 914-6 Technical Forum 11-03-1999, 05:45 PM
Replies: 8
Views: 1,443
Posted By halbl
You will notice the Bug Pack box also has venting...

You will notice the Bug Pack box also has venting around the lid. I mounted mine higher than the oil filler so anything that gets pushed up will drain down. Note of caution= be sure to use a high...
Forum: Porsche 914 & 914-6 Technical Forum 10-26-1999, 09:36 PM
Replies: 10
Views: 531
Posted By halbl
The 205x50s will work on the Fuchs. Book says so...

The 205x50s will work on the Fuchs. Book says so and I have them. (Michelin) When they are installed the shop should check clearance at the rear fender well before releasing the car. If no fit they...
Forum: Porsche 914 & 914-6 Technical Forum 10-26-1999, 05:28 AM
Replies: 6
Views: 585
Posted By halbl
The stiffening kit is pretty straight forward...

The stiffening kit is pretty straight forward except the instructions do not assume amatuer status of the installer. First make a stiff cardboard copy of the pieces. They come in flat sheet metal...
Forum: Porsche 914 & 914-6 Technical Forum 10-01-1999, 07:07 PM
Replies: 4
Views: 457
Posted By halbl
If you have the Crane HI-6 with the rev limiter,...

If you have the Crane HI-6 with the rev limiter, it will drop fire to cylinders at whatever setting you have chosen, to avoid over-rev of engine. I think mine came set at zero, zero.
Forum: Porsche 914 & 914-6 Technical Forum 10-01-1999, 05:27 AM
Replies: 5
Views: 703
Posted By halbl
My son's vw bus has a 914 2.0 with the single...

My son's vw bus has a 914 2.0 with the single progressive carb and freeway flyer tranny. Works fine at mid RPM but has a few flat spots at lower RPM. Flat out, it seems to guzzle gas. We are going...
Forum: Porsche 914 & 914-6 Technical Forum 09-20-1999, 07:59 PM
Replies: 2
Views: 446
Posted By halbl
wiper parking on passenger side

I recently had my wiper motors RR and now they park on the passenger side. The repairman will redo the job but is not sure what he did wrong. Help appreciated.
Forum: Porsche 914 & 914-6 Technical Forum 09-20-1999, 06:53 PM
Replies: 6
Views: 495
Posted By halbl
Did you post adjust at .006?? I think the valve...

Did you post adjust at .006?? I think the valve adjust for 2.0L is .006 intake, and .008 exhaust.
Forum: Porsche 914 & 914-6 Technical Forum 09-04-1999, 06:04 AM
Replies: 7
Views: 508
Posted By halbl
You need to look to see if the heater blower...

You need to look to see if the heater blower comes on when you pull the defroster lever. If not the circuit is broken. As JPN pointed out they are on the same circuit.
Forum: Porsche 914 & 914-6 Technical Forum 07-24-1999, 04:33 AM
Replies: 9
Views: 566
Posted By halbl
I AGREE WITH JP. Had a cooking stove that seemed...

I AGREE WITH JP. Had a cooking stove that seemed to burn things. So, put water and candy thermo in stove and set at 350 degrees. The thermo actually showed 375, so I pulled the knob off and...
Forum: Porsche 914 & 914-6 Technical Forum 07-23-1999, 03:43 PM
Replies: 4
Views: 511
Posted By halbl
When upward leverage is put on the bale I find it...

When upward leverage is put on the bale I find it helpful to have a strong rag doubled around the bale for holding additional pressure. Helps if the bale tends to pass the groove or lever slips.
Forum: Porsche 914 & 914-6 Technical Forum 07-23-1999, 03:37 PM
Replies: 5
Views: 498
Posted By halbl
JP, DAVE, I could use some advice on the same...

JP, DAVE, I could use some advice on the same subject. What is the correct timing for a 2.0L with mild cam, 009 distributor and single progressive 32/36 carberator. Help solve an argument. Is it...
Forum: Porsche 914 & 914-6 Technical Forum 06-15-1999, 10:46 AM
Replies: 4
Views: 443
Posted By halbl
I think the side shifter uses the later engine...

I think the side shifter uses the later engine mount with a hole in it for the shift rod.
Forum: Porsche 914 & 914-6 Technical Forum 06-14-1999, 06:52 AM
Replies: 12
Views: 582
Posted By halbl
When you get it back together, be sure you carry...

When you get it back together, be sure you carry a good fire extinguisher with you. All the time! Saved me once from a bare wire short between the starter and alternator.
Forum: Porsche 914 & 914-6 Technical Forum 05-20-1999, 07:15 PM
Replies: 2
Views: 481
Posted By halbl
Check out the tech article this site about...

Check out the tech article this site about rebuilding the sending unit in the tank. The unit is installed in the top of the tank and has three brass wires top to bottom that work as contacts and a...
Showing results 1 to 25 of 66

 
Forum Jump

All times are GMT -8. The time now is 04:55 AM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2020 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.