Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums


Showing results 1 to 25 of 162
Search took 0.03 seconds.
Search: Posts Made By: forte500
Forum: 911 / 930 Turbo & Super Charging Forum 12-06-2015, 05:36 PM
Replies: 17
Views: 983
Posted By forte500
I run the NGK FR5 in the EFI 3.4L modded motor...

I run the NGK FR5 in the EFI 3.4L modded motor with 1.2Bar boost. At .32 gap I was getting spark blow out and backfire at full boost; regapped to .24 and runs perfectly.
Forum: 911 / 930 Turbo & Super Charging Forum 11-24-2015, 03:41 PM
Replies: 11
Views: 1,065
Posted By forte500
Thanks fellas....my mind is made up..ptfe all the...

Thanks fellas....my mind is made up..ptfe all the way. Gas smell is making me hate the car , which reminds me of an old Camaro I had in high school.
Forum: 911 / 930 Turbo & Super Charging Forum 11-24-2015, 03:41 AM
Replies: 11
Views: 1,065
Posted By forte500
SS Braided Fuel Lines - Smell!!

After chasing a gas "vapor" smell for several days, I concluded the smell is coming from the SS braided fuel lines. Not happy about replacing all these (4yrs old), but I cannot stand the smell, risk...
Forum: 911 / 930 Turbo & Super Charging Forum 11-22-2015, 12:39 PM
Replies: 1
Views: 289
Posted By forte500
Thermostat Plug

Folks,

Just replaced the lower plug & crush washer (shown in pic) due to slow leak.....still leaking.... How tight do these alum plugs need to be to seal? What tool do you use?

ps. I made tool...
Forum: 911 / 930 Turbo & Super Charging Forum 11-10-2015, 06:23 PM
Replies: 20
Views: 1,125
Posted By forte500
I had same dilemma......after OEM clutch...

I had same dilemma......after OEM clutch shattered I reached out to many other companies....KEP was BY FAR the most knowledgeable, responsive, and provided a "turnkey" solution for my application...
Forum: Porsche 911 Used Parts For Sale & Wanted 11-01-2015, 11:57 AM
Replies: 1
Views: 274
Posted By forte500
FS: Sachs Race Eng. Pressure Plate

Used (< 6K miles) on Aluminum Sachs Race Engineering Pressure Plate and Throw-out bearing. Replaced while "chasing" down a clutch problem (was defective disk), and upgraded with KEP stage 2 to handle...
Forum: Porsche 911 Used Parts For Sale & Wanted 11-01-2015, 11:47 AM
Replies: 1
Views: 197
Posted By forte500
FS: G50 Master and Slave Cylinder

Used (< 6K miles) on Master Cylinder and Slave Cylinder. Both were replaced while "chasing" down a clutch problem (turned out to be defective disk). No leaks and look new. Asking $60 for both.
...
Forum: Porsche 911 Used Parts For Sale & Wanted 11-01-2015, 11:43 AM
Replies: 1
Views: 300
Posted By forte500
FS: Sparco Evo 2 Seat w/Rails

Excellent condition Sparco Evo 2 seat for sale. Came with car, but I never used. Has rails attached. Cloth in perfect condition. Must go. $250.

Frank
Stamford, CT. 203.482.5077
...
Forum: 911 / 930 Turbo & Super Charging Forum 07-25-2015, 04:35 AM
Replies: 2
Views: 245
Posted By forte500
Yes....I made a clamp to hold the pedal down....

Yes....I made a clamp to hold the pedal down. Should I bleed the next day with it "down"?


Why would there be a stream of little bubbles each time i crack the bleeder with 2 min in ...
Forum: 911 / 930 Turbo & Super Charging Forum 07-25-2015, 04:07 AM
Replies: 2
Views: 245
Posted By forte500
Clutch bleed mystery

Per my last post, I was able to re-bleed my clutch system and get back the ability to disengage the clutch and get into gear (thought it was something more serious)..but after a day or so, the...
Forum: 911 / 930 Turbo & Super Charging Forum 07-15-2015, 08:25 AM
Replies: 3
Views: 265
Posted By forte500
Clutch held down ?

Clutch held down ?
Forum: 911 / 930 Turbo & Super Charging Forum 07-15-2015, 07:56 AM
Replies: 3
Views: 265
Posted By forte500
Power Bleeder - Clutch ?

Do you recommend holding the clutch "down" while you power bleed (Motive) or does it matter? Replacing master and slave cylinders.

Thanks
Frank
Forum: 911 / 930 Turbo & Super Charging Forum 07-11-2015, 06:02 PM
Replies: 0
Views: 317
Posted By forte500
Fuel Pump recommendation

Folks,

I've been noticing my "rear" fuel pump beginning to squeal (more than whine) louder, and I'm afraid this may be a sign it's failing.. It was replaced when my hot rod engine was rebuilt a...
Forum: 911 / 930 Turbo & Super Charging Forum 07-08-2015, 09:08 AM
Replies: 9
Views: 525
Posted By forte500
Problem Solved!

So, I inspected (via inspection plate - on my lift) the clutch fork, slave plunger travel, and confirmed everything looked fine (good travel, no cracked bosses, pp was moving in /out, etc.). I even...
Forum: 911 / 930 Turbo & Super Charging Forum 07-05-2015, 05:28 PM
Replies: 9
Views: 525
Posted By forte500
Thanks for replies..... Pumping doesn't...

Thanks for replies.....


Pumping doesn't seem to make a difference....clutch pedal feel normal. If my wife depresses clutch, I can see throughout fork moving back in forth in the tranny...
Forum: 911 / 930 Turbo & Super Charging Forum 07-05-2015, 05:04 PM
Replies: 9
Views: 525
Posted By forte500
G50 clutch not disengaging...help?

Guys,

Some of you might recall..I have a 86' 930 fully built by Peter Dawe, including G50 conversion. Well....everything basically new (6K miles on Eng and Trans) and I just experienced some...
Forum: 911 / 930 Turbo & Super Charging Forum 04-07-2015, 11:11 AM
Replies: 20
Views: 2,225
Posted By forte500
Decided to hold onto it....only going up in...

Decided to hold onto it....only going up in value. Thanks!
Forum: 911 / 930 Turbo & Super Charging Forum 04-02-2015, 04:03 PM
Replies: 20
Views: 2,225
Posted By forte500
Correction 1000 hrs ...

Correction 1000 hrs ...
Forum: 911 / 930 Turbo & Super Charging Forum 04-01-2015, 04:44 PM
Replies: 20
Views: 2,225
Posted By forte500
Thanks fellas ..I prob won't end up selling....

Thanks fellas ..I prob won't end up selling. Unfortunately, I have little time to enjoy her. Most of the fun was building it... I put at least a hundred hours in myself.
Dawes really took a lot...
Forum: 911 / 930 Turbo & Super Charging Forum 03-30-2015, 05:41 PM
Replies: 20
Views: 2,225
Posted By forte500
FS: Porsche 930 turbo - Motec

http://forums.pelicanparts.com/porsche-cars-sale/858432-fs-porsche-930-turbo-motec.html


http://forums.pelicanparts.com/uploads24/DSC_00801427766086.jpg
Forum: Porsche Cars For Sale 03-30-2015, 05:35 PM
Replies: 0
Views: 2,529
Posted By forte500
FS: Porsche 930 turbo - Motec

Porsche 930 – Motec

1986 Porsche 930 turbo. Black on black with BEST of everything! Body in near perfect condition (66,024 miles), no accidents or dents, and meticulously cared for. Entire drive...
Forum: 911 / 930 Turbo & Super Charging Forum 12-23-2013, 09:17 PM
Replies: 42
Views: 5,287
Posted By forte500
https://scontent-a-lga.xx.fbcdn.net/hphotos-ash2/3...

https://scontent-a-lga.xx.fbcdn.net/hphotos-ash2/396138_3006362762681_2133672526_n.jpg

Think these 18" /315's fit just right...and look like the IMSA 935's rims (i.e. era-appropriate). I'll try...
Forum: 911 / 930 Turbo & Super Charging Forum 12-23-2013, 02:48 PM
Replies: 42
Views: 5,287
Posted By forte500
http://forums.pelicanparts.com/uploads22/Porsche+9...

http://forums.pelicanparts.com/uploads22/Porsche+9301387842240.jpg



The better the fitment under the fender (height and width) on any car - looks the best, to a degree.

18" look the best and...
Forum: 911 / 930 Turbo & Super Charging Forum 11-05-2013, 09:48 AM
Replies: 15
Views: 1,445
Posted By forte500
Looking at it from a different perspective....in...

Looking at it from a different perspective....in 1st, 2nd, and some of 3rd - if my car pulled any harder, it would lose traction. I have to deliberately feather the gas to not fishtail (even at...
Forum: 911 / 930 Turbo & Super Charging Forum 11-04-2013, 10:05 AM
Replies: 15
Views: 1,445
Posted By forte500
You think? Maybe I'm just used to the power...

You think? Maybe I'm just used to the power...
Showing results 1 to 25 of 162

 
Forum Jump

All times are GMT -8. The time now is 08:37 AM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2020 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.