Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums


Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: Jeron
Forum: BMW 6,7,8-Series Technical Forum 01-03-2017, 08:38 AM
Replies: 11
Views: 35,306
Posted By Jeron
Is the noise only at Cold Start? If so, it is...

Is the noise only at Cold Start? If so, it is probably your secondary air pump which runs for about a minute to heat up the cats. It sounds like a hair drier and gets noisier with age. This air...
Forum: BMW 5-Series E28/E34/E39/E60/F10/GT 01-22-2015, 03:23 PM
Replies: 5
Views: 738
Posted By Jeron
The dipstick tube is easy to remove. The rubber...

The dipstick tube is easy to remove. The rubber drain tube will have to be pulled off of the metal dipstick tube and there may be a wire or tube that is strapped to the metal tube. Otherwise it is...
Forum: BMW 3-Series E46 (1999-2005) 01-22-2015, 02:05 PM
Replies: 7
Views: 773
Posted By Jeron
Just turning the key to ON should not drop the...

Just turning the key to ON should not drop the voltage that much.

Do these numbers drop when the key is ON but engine is OFF?
Battery 12.42
Jump Box under Hood 12.42
Alternator red cable that...
Forum: 101 Projects Discussion Forum: BMW 3-Series 01-22-2015, 09:00 AM
Replies: 3
Views: 161
Posted By Jeron
To find your answer, check aftermarket seat...

To find your answer, check aftermarket seat manufacturers and see if they sell different mounting brackets for E36 and E46 applications.
Forum: BMW 5-Series E28/E34/E39/E60/F10/GT 01-22-2015, 08:09 AM
Replies: 5
Views: 738
Posted By Jeron
That looks like the dipstick tube. The Y...

That looks like the dipstick tube.

The Y part is the PCV drain which comes down as a hose and joins the dipstick tube just before it enters the top of the pan.

On that model BMW the PCV is...
Forum: BMW 3-Series E46 (1999-2005) 01-22-2015, 08:03 AM
Replies: 7
Views: 773
Posted By Jeron
The voltage regulator is installed in the...

The voltage regulator is installed in the alternator and I dont think it is considered a replaceable part.

When the alternator is tested the voltage regulator is tested as well since it is...
Forum: 101 Projects Discussion Forum: BMW 3-Series 05-17-2012, 02:01 PM
Replies: 11
Views: 912
Posted By Jeron
All he is looking for is everyday brakes that...

All he is looking for is everyday brakes that have low dust.

I just noticed that drilled/slotted/grooved was brought up.
Only get plain blank rotors.
Forum: 101 Projects Discussion Forum: BMW 3-Series 05-17-2012, 01:57 PM
Replies: 8
Views: 630
Posted By Jeron
How is your clutch? Is it low on power or does...

How is your clutch?
Is it low on power or does it feel unresponsive, like a small delay? (if unresponsive then check the engine mounts)

Pull the whole intake section and carefully inspect for...
Forum: 101 Projects Discussion Forum: BMW 3-Series 05-17-2012, 01:53 PM
Replies: 21
Views: 7,816
Posted By Jeron
Since you seem desperate... Pull the front...

Since you seem desperate...

Pull the front rotors
check the mating surface where it meets the rim (the front face)
check the mating surface where it meets the hub (the back face)
check the hub...
Forum: 101 Projects Discussion Forum: BMW 3-Series 05-17-2012, 01:45 PM
Replies: 2
Views: 559
Posted By Jeron
I pulled the starter and transmission without...

I pulled the starter and transmission without pulling the intake.

You need about 3 feet worth of socket extensions to make the job easier.
Forum: 101 Projects Discussion Forum: BMW 3-Series 05-17-2012, 01:42 PM
Replies: 11
Views: 912
Posted By Jeron
(Funny the rotors on my BMW bike make that...

(Funny the rotors on my BMW bike make that buzzing noise too. I thought it was loose bobbins but after putting on a new set they still buzz.)

Any brake pad will be better than stock, Pagid or...
Forum: 101 Projects Discussion Forum: BMW 3-Series 02-06-2012, 11:20 AM
Replies: 2
Views: 840
Posted By Jeron
Use a dremmel to remove the crimps, reuse the...

Use a dremmel to remove the crimps, reuse the fittings, buy bulk hose and hose clamp.

The screen inside the reservoir can be unscrewed but not removed from the reservoir. Unscrew it and wash the...
Forum: 101 Projects Discussion Forum: BMW 3-Series 01-10-2012, 12:25 PM
Replies: 2
Views: 493
Posted By Jeron
The front bumper comes off very easy. It is...

The front bumper comes off very easy. It is substantially held on with 4 nuts which are under the trim molding.

I cant say for sure if there are any other fasteners on a stock bumper although you...
Forum: 101 Projects Discussion Forum: BMW 3-Series 12-27-2011, 11:17 AM
Replies: 3
Views: 602
Posted By Jeron
Also consider that the engine itself can be...

Also consider that the engine itself can be tilted a few degrees to allow better access to the top tranny bolts.
Forum: 101 Projects Discussion Forum: BMW 3-Series 12-27-2011, 11:14 AM
Replies: 6
Views: 369
Posted By Jeron
I dont remember putting sealant on the oil pan...

I dont remember putting sealant on the oil pan gasket.

Some gaskets, such as the Valve cover, have a few specific troublesome areas where you put dab of sealant but they dont call for sealant on...
Forum: BMW 3-Series E46 (1999-2005) 11-14-2011, 08:58 PM
Replies: 5
Views: 3,767
Posted By Jeron
I suspect it is a transmission problem. ...

I suspect it is a transmission problem.

Ether way a BMW dealer or properly equipped BMW mechanic should be able to diagnose it.

A standard repair shop might not have the proper BMW computer...
Forum: BMW 3-Series E46 (1999-2005) 04-20-2011, 12:19 PM
Replies: 1
Views: 551
Posted By Jeron
Use this to compare tire diameters: ...

Use this to compare tire diameters:

http://www.discounttiredirect.com/direct/brochure/info/tmpInfoTireMath.jsp

You probably wont even notice if you were to simply buy 1 new different model...
Forum: 101 Projects Discussion Forum: BMW 3-Series 04-20-2011, 12:10 PM
Replies: 3
Views: 563
Posted By Jeron
I see. I didnt realize, at first read, that you...

I see. I didnt realize, at first read, that you wanted to mill the block to increase compression.

I would talk to the machine shop. Not only about the specs but about whether this is the best or...
Forum: 101 Projects Discussion Forum: BMW 3-Series 04-20-2011, 12:06 PM
Replies: 10
Views: 1,158
Posted By Jeron
The p/s uses plain ATF. Is there a reason ...

The p/s uses plain ATF.

Is there a reason "Michael" thinks you have petosin in there?
Forum: 101 Projects Discussion Forum: BMW 3-Series 04-20-2011, 12:02 PM
Replies: 2
Views: 342
Posted By Jeron
The most common gearbox leak is the gear sensor...

The most common gearbox leak is the gear sensor on the side.

In the bell housing you have the engine rear main and the gearbox input shaft seals. You need to determine if it is engine oil or...
Forum: 101 Projects Discussion Forum: BMW 3-Series 04-20-2011, 11:58 AM
Replies: 2
Views: 274
Posted By Jeron
What indication do you have that your diff may be...

What indication do you have that your diff may be bad?
Forum: 101 Projects Discussion Forum: BMW 3-Series 04-20-2011, 11:56 AM
Replies: 3
Views: 563
Posted By Jeron
I dont remember exactly but my poor memory says...

I dont remember exactly but my poor memory says 25 thousandths.

The machine shop will tell you how much can safely be milled and there are also oversize head gaskets. It is highly unlikely you...
Forum: 101 Projects Discussion Forum: BMW 3-Series 04-12-2011, 09:22 AM
Replies: 7
Views: 851
Posted By Jeron
Were you careful to put the clutch disk on...

Were you careful to put the clutch disk on correctly. The disk is marked "gear box side" (except it is in German)
Forum: BMW 5-Series E28/E34/E39/E60/F10/GT 06-07-2010, 08:31 AM
Replies: 3
Views: 724
Posted By Jeron
There is "slop" to reduce the head plus you can...

There is "slop" to reduce the head plus you can buy an oversize gasket if necessary.

Get the over size gasket options, then ask your machine shop. I am sure you will be fine.
Forum: 101 Projects Discussion Forum: BMW 3-Series 04-01-2010, 12:11 PM
Replies: 3
Views: 722
Posted By Jeron
The tear has allowed dirt in and it is binding...

The tear has allowed dirt in and it is binding the piston. You need a $10 caliper rebuild kit.

Rebuilding it is not as easy as it seems. Make sure to completely disassemble the caliper, clean it...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -8. The time now is 06:22 PM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.