Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums


Showing results 1 to 25 of 222
Search took 0.03 seconds.
Search: Posts Made By: Frostie
Forum: Porsche 911 Technical Forum 10-23-2010, 08:13 AM
Replies: 10
Views: 857
Posted By Frostie
Question Need Advice, no power, extreme backfiring

I really need some advice on what to do next to my project 911 to try to get the engine to run right. :confused:

The engine starts okay, but there is excessive backfiring especially at idle as i...
Forum: Porsche 911 Technical Forum 06-15-2010, 10:14 AM
Replies: 11
Views: 23,757
Posted By Frostie
thanks for the feed back... I wasn't sure if...

thanks for the feed back... I wasn't sure if that spray on carb cleaner works as well as soaking in a bath of solvent.

That Sea Foam product sounds good.
Pine Sol? I never thought of using a...
Forum: Porsche 911 Technical Forum 06-15-2010, 09:19 AM
Replies: 11
Views: 23,757
Posted By Frostie
Question Best solvent to clean gummed up carbs?

What would you use to clean up weber carbs that have been sitting for a few years with old gas? As well some crap might have went through carbs.

I have removed the webers and was going to take...
Forum: Porsche 911 Technical Forum 04-01-2006, 07:49 PM
Replies: 46
Views: 6,542
Posted By Frostie
a little dirty... but here are mine.. ...

a little dirty... but here are mine..


http://forums.pelicanparts.com/uploads7/kkkkk1143953344.jpg
Forum: Porsche 911 Technical Forum 04-01-2006, 07:36 PM
Replies: 15
Views: 1,501
Posted By Frostie
If it is done right it is not that dangerous, but...

If it is done right it is not that dangerous, but to do it right adds up $$$ (ignition retard, fuel pressure moniture, rpm switchs, ect ect)

Here is a pic of my 90hp wet system
...
Forum: Porsche 911 Technical Forum 03-03-2006, 10:27 PM
Replies: 7
Views: 883
Posted By Frostie
Tom B, I hate to change the subject but, what is...

Tom B, I hate to change the subject but, what is that mounted on your back seat????
Forum: Porsche 911 Technical Forum 03-02-2006, 03:04 PM
Replies: 190
Views: 22,978
Posted By Frostie
true enough Fastbacker, Got myself a new tow...

true enough Fastbacker, Got myself a new tow vehicle now. The toyota did surprisingly well thou…. But then again 5.71:1 gears does help =)

I'll have the 911 off the trailer and on the road this...
Forum: Porsche 911 Technical Forum 03-02-2006, 04:38 AM
Replies: 190
Views: 22,978
Posted By Frostie
So much to do .....:rolleyes: So little time...

So much to do .....:rolleyes:
So little time ..... :(

http://forums.pelicanparts.com/uploads7/P42600371141306551.jpg

http://forums.pelicanparts.com/uploads7/P42600381141306623.jpg
...
Forum: Porsche 911 Technical Forum 12-10-2005, 09:46 PM
Replies: 252
Views: 12,391
Posted By Frostie
Damn, I wish I could come down for this one,...

Damn, I wish I could come down for this one, maybe next time, not many pelicans in my neck of the woods (Quesnel).
Forum: Porsche 911 Used Parts For Sale & Wanted 07-14-2005, 05:06 AM
Replies: 15
Views: 1,187
Posted By Frostie
Yes Dave, it is a nice wing. Would you consider...

Yes Dave, it is a nice wing. Would you consider selling it with the lid? (I need everything in the picture). Drop me an e-mail @ snowmanfrostie@telus.net
Forum: Porsche 911 Used Parts For Sale & Wanted 05-26-2005, 04:13 PM
Replies: 17
Views: 1,967
Posted By Frostie
For the requests to see more pictures of the rims...

For the requests to see more pictures of the rims

3 are shown the 4th is in perfect condition it is shown above beside my car, it is right now in my friends shop hanging on wall.
...
Forum: Porsche 911 Used Parts For Sale & Wanted 05-26-2005, 03:37 PM
Replies: 17
Views: 1,967
Posted By Frostie
Colin (Cowtown) sorry, you are correct, it is 52...

Colin (Cowtown) sorry, you are correct, it is 52 not 152

Alex(’70 Fasty) been busy as hell but I’ll see what I can find out for you. I’ll be sending them from Quesnel, BC, V2J 6S2

Rob_in_sotx...
Forum: Porsche 911 Used Parts For Sale & Wanted 05-25-2005, 09:52 AM
Replies: 17
Views: 1,967
Posted By Frostie
Strupgolf...I'll get you some more pictures...

Strupgolf...I'll get you some more pictures tonight to try to show the finnish.

I would get them powder coated like this guy did:
...
Forum: Porsche 911 Used Parts For Sale & Wanted 05-25-2005, 07:56 AM
Replies: 17
Views: 1,967
Posted By Frostie
=( too wide for my sc body ...

=( too wide for my sc body


http://forums.pelicanparts.com/uploads5/P30300331117036540.jpg
Forum: Porsche 911 Used Parts For Sale & Wanted 05-25-2005, 07:54 AM
Replies: 17
Views: 1,967
Posted By Frostie
Kycarguy 935 hhmmmm, you know. I think you might...

Kycarguy 935 hhmmmm, you know. I think you might be right. I just went by the quick measurements that I got off them from my tape, as seen above, but…going by what is written on the rim they are...
Forum: Porsche 924/944/968 Used Parts For Sale & Wanted 05-24-2005, 09:53 PM
Replies: 0
Views: 517
Posted By Frostie
Wink BBS rims 18x11 & 18x9 $1000

BBS rims 18x11 & 18x9 $1000

A set of BBS rims front are 18x9 and the rear are 18x11. The rims were purchased for a project but they are too wide. I believe they were from a 996. Included is the...
Forum: Porsche 911 Used Parts For Sale & Wanted 05-24-2005, 09:50 PM
Replies: 17
Views: 1,967
Posted By Frostie
;)http://forums.pelicanparts.com/uploads5/P5240057...

;)http://forums.pelicanparts.com/uploads5/P52400571117000169.jpg http://forums.pelicanparts.com/uploads5/P52400581117000184.jpg http://forums.pelicanparts.com/uploads5/P52400591117000201.jpg...
Forum: Porsche 911 Used Parts For Sale & Wanted 05-24-2005, 09:48 PM
Replies: 17
Views: 1,967
Posted By Frostie
Wink BBS rims 18x11 & 18x9 $1000

BBS rims 18x11 & 18x9 $1000

A set of BBS rims front are 18x9 and the rear are 18x11. The rims were purchased for a project but they are too wide. I believe they were from a 996. Included is the...
Forum: Porsche 911 Technical Forum 05-24-2005, 11:40 AM
Replies: 11
Views: 618
Posted By Frostie
Thanks Mike... PBH, I'm a little nervous...

Thanks Mike...

PBH, I'm a little nervous about running it below the car as the fuel line would be the lowest point and the first to hit if I were ever too bottom out....but that would sure make it...
Forum: Porsche 911 Technical Forum 05-24-2005, 10:55 AM
Replies: 11
Views: 618
Posted By Frostie
Does anyone know the conversion of 'an' to...

Does anyone know the conversion of 'an' to inches? I'm not familiar with this unit. I've been buying my line by inches ID
Forum: Porsche 911 Technical Forum 05-24-2005, 10:42 AM
Replies: 11
Views: 618
Posted By Frostie
No it isn't CIS, I'm running a set of webbers on...

No it isn't CIS, I'm running a set of webbers on a 3.0. Yes i thought about the fish tape idea to help run the line hhhhmmmm

No The old line is pretty much stuck in place….

Maybe the 1/2" is a...
Forum: Porsche 911 Technical Forum 05-24-2005, 09:27 AM
Replies: 11
Views: 618
Posted By Frostie
For safety if I referred to NHRA rules ...

For safety if I referred to NHRA rules

"Fuel gauge lines in the driver compartment must be steel-braided with steel fittings."

Maybe that is what I’ll do.
Forum: Porsche 911 Technical Forum 05-24-2005, 08:33 AM
Replies: 11
Views: 618
Posted By Frostie
bump What is legal for racing?

bump

What is legal for racing?
Forum: Porsche 911 Technical Forum 05-23-2005, 08:47 PM
Replies: 11
Views: 618
Posted By Frostie
Question HELP! How do I run a new fuel line???

HELP! How do I run a new fuel line???

On my 74 the fuel line is damaged inside the tunnel so I need to run a new line. I'm running a new 1/2" ID fuel line from the tank to the fuel pump which is...
Forum: Porsche 911 Technical Forum 05-18-2005, 04:06 PM
Replies: 21
Views: 1,111
Posted By Frostie
Scaffolding

Scaffolding
Showing results 1 to 25 of 222

 
Forum Jump

All times are GMT -8. The time now is 07:48 AM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2020 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.