Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums


Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: manbridge 74
Forum: Off Topic Discussions Yesterday, 07:47 PM
Replies: 35
Views: 708
Posted By manbridge 74
Yep, they make two in 3/8 inch, one 35 ft/lbs and...

Yep, they make two in 3/8 inch, one 35 ft/lbs and the other 50. Use the 1/2 inch M18 almost everyday for awhile now as well.
Forum: Porsche 911 Technical Forum Yesterday, 06:55 PM
Replies: 31
Views: 938
Posted By manbridge 74
Late I know but Carrera knobs are screwed down...

Late I know but Carrera knobs are screwed down from the top I think.
Forum: Porsche Marketplace Discussion 06-18-2018, 08:29 PM
Replies: 2
Views: 190
Posted By manbridge 74
Dealership techs?

Dealership techs?
Forum: Porsche 911 Technical Forum 06-17-2018, 12:48 PM
Replies: 19
Views: 609
Posted By manbridge 74
When you get there check the other side too....

When you get there check the other side too....
Forum: Porsche 911 Technical Forum 06-17-2018, 12:44 PM
Replies: 2
Views: 124
Posted By manbridge 74
Start with the power and ground. Should be real...

Start with the power and ground. Should be real close to battery voltage. Voltage drop measurement would be next. Probably a dirty connection.
Forum: Off Topic Discussions 06-17-2018, 12:40 PM
Replies: 33
Views: 1,154
Posted By manbridge 74
Sounds fair but I’d have wanted to see a pic. ...

Sounds fair but I’d have wanted to see a pic. People in the business see these aftermarket exhausts and can point out where they regularly crack. Most are pretty brittle....
Forum: Porsche Marketplace Discussion 06-14-2018, 04:05 PM
Replies: 46
Views: 1,552
Posted By manbridge 74
I say it will end reserve not met....

I say it will end reserve not met....
Forum: Porsche Marketplace Discussion 06-13-2018, 08:34 PM
Replies: 29
Views: 840
Posted By manbridge 74
Remember the M491 they had over at Edmunds? Had...

Remember the M491 they had over at Edmunds? Had to laugh at their attempts to improve the car for resale. Went to France for around $25K circa 2012.
Forum: Porsche 911 Technical Forum 06-13-2018, 10:25 AM
Replies: 13
Views: 467
Posted By manbridge 74
Interesting side fact. When a 964 comes in for...

Interesting side fact. When a 964 comes in for service a guy is supposed to pull each coil quick disconnect off one by one to check each circuit’s ability to run the car...
Forum: Porsche 911 Technical Forum 06-12-2018, 06:53 PM
Replies: 5
Views: 263
Posted By manbridge 74
We had a early 75 in that looked original in...

We had a early 75 in that looked original in every way. Had a orange bar badge...
Forum: Porsche 911 Technical Forum 06-12-2018, 11:52 AM
Replies: 44
Views: 1,856
Posted By manbridge 74
Also of note when tracking the 911 most track...

Also of note when tracking the 911 most track based tire makers would have you run as much caster as possible for high speed stability and feel for loss of traction. Probably complements the stiff...
Forum: Porsche Marketplace Discussion 06-11-2018, 10:33 AM
Replies: 46
Views: 1,552
Posted By manbridge 74
So does it have a later trans to work with...

So does it have a later trans to work with electric speedo? Later trans is a higher geared which is not the right way to go with a 2.7RS...
Forum: Porsche 911 Technical Forum 06-11-2018, 10:19 AM
Replies: 44
Views: 1,856
Posted By manbridge 74
Set caster to 5 or 5.5 degrees for a more lively...

Set caster to 5 or 5.5 degrees for a more lively feel after all the other stuff mentioned above.
Forum: Porsche 911 Technical Forum 06-11-2018, 12:48 AM
Replies: 6
Views: 437
Posted By manbridge 74
Make lemonade from lemons by sending it to...

Make lemonade from lemons by sending it to Supertec. They can replace the center section with a hard anodized aluminum fan hub. Or steel if desired.
Forum: Porsche Marketplace Discussion 06-10-2018, 08:00 PM
Replies: 46
Views: 1,552
Posted By manbridge 74
I shall dub it Hodge-Podge...

I shall dub it Hodge-Podge...
Forum: Off Topic Discussions 06-10-2018, 02:52 AM
Replies: 60
Views: 1,557
Posted By manbridge 74
Letting people live a lie used to be called the...

Letting people live a lie used to be called the worst kind of evil.
Forum: Off Topic Discussions 06-09-2018, 01:48 AM
Replies: 72
Views: 1,590
Posted By manbridge 74
Like Randy mentioned the Fords had more designed...

Like Randy mentioned the Fords had more designed in deficiency than GM. Funny backronyms were true back in the day. Not so much in 2018.

Saw an aluminum F150 today in traffic covered in dents....
Forum: Porsche 911 Technical Forum 06-07-2018, 03:16 AM
Replies: 31
Views: 938
Posted By manbridge 74
Take the shift shaft out and slide boot up from...

Take the shift shaft out and slide boot up from bottom. This type of knob can be a pain to remove without destroying it.
Forum: Off Topic Discussions 06-05-2018, 10:13 AM
Replies: 55
Views: 2,446
Posted By manbridge 74
Weigh it at some point.... Well done!

Weigh it at some point....

Well done!
Forum: Porsche 911 Technical Forum 06-03-2018, 07:53 PM
Replies: 39
Views: 2,395
Posted By manbridge 74
Cool beans, rock on....

Cool beans, rock on....
Forum: Off Topic Discussions 06-03-2018, 07:27 PM
Replies: 25
Views: 864
Posted By manbridge 74
I expect the last flat six models will only go up...

I expect the last flat six models will only go up in desirability. The are sooo much more responsive than the laggy fours. Very competent cars....
Forum: Porsche 911 Technical Forum 06-03-2018, 01:37 PM
Replies: 16
Views: 411
Posted By manbridge 74
Have you cleaned the pre-filter in the tank? It...

Have you cleaned the pre-filter in the tank? It would be a drag to replace the pump and have the same noise from cavitation.....
Forum: Porsche 911 Technical Forum 06-03-2018, 01:31 PM
Replies: 14
Views: 437
Posted By manbridge 74
Did you replace the caliper dust seals with...

Did you replace the caliper dust seals with Porsche parts? The aftermarket seals don't fit well. Most old 911s have cracks in the dust seals from age. Once water and corrosive brake dust gets in...
Forum: Porsche 911 Technical Forum 06-03-2018, 01:02 PM
Replies: 27
Views: 855
Posted By manbridge 74
Been working on a 79 SC with the Firehawk Indy...

Been working on a 79 SC with the Firehawk Indy 500. Drove nice while throwing it around a few turns. Brakes don’t lock up easy which is my clue to old or hard compound tires. It’s the goofy name...
Forum: Porsche 911 Technical Forum 06-02-2018, 07:04 AM
Replies: 9
Views: 461
Posted By manbridge 74
Looking at worn cam gear teeth shows that a lot...

Looking at worn cam gear teeth shows that a lot of ferrous metal is available to abrade the scavenge side of the oil pump at the least. No issues with using more magnets that I can see.
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -8. The time now is 05:16 PM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.