Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums


Showing results 1 to 25 of 47
Search took 0.02 seconds.
Search: Posts Made By: FrankM_
Forum: Porsche 911 Technical Forum Today, 05:18 AM
Replies: 18
Views: 271
Posted By FrankM_
Could your tuner/amp have given up on the right...

Could your tuner/amp have given up on the right side ? Did you try to run the left speakers (known good) fron the right amp output ?

And beware, in my 911 there was an aftermarket amp under the...
Forum: Porsche 911 Technical Forum 07-14-2019, 09:41 AM
Replies: 26
Views: 1,007
Posted By FrankM_
I am quite routined now in getting the top of the...

I am quite routined now in getting the top of the box off in about 10-15 minutes while it remains connected. Getting the clips off the first time might take longer.

To put the clips back on, I...
Forum: Porsche 911 Technical Forum 07-14-2019, 09:30 AM
Replies: 8
Views: 436
Posted By FrankM_
No worries mate ! I am trying to map all the...

No worries mate !

I am trying to map all the electronics in my car just so I can service it for the next 35 years. The cruise control was my first (had the same issue than yours), have done some...
Forum: Porsche 911 Technical Forum 07-12-2019, 09:29 AM
Replies: 8,105
Views: 934,527
Posted By FrankM_
Yes on a 1985 and before you need to pull the...

Yes on a 1985 and before you need to pull the windscreen out, I believe it is from the new 1986 dash with the wider vents that the dash fixing changed and they can be removed without the windscreen...
Forum: Porsche 911 Technical Forum 07-12-2019, 09:13 AM
Replies: 8
Views: 436
Posted By FrankM_
Replace the 0,1 uF capacitor near the Guenther...

Replace the 0,1 uF capacitor near the Guenther relay ( lower right side of the board when you hold the connector up ).
It is the capacitor that has ‘one leg up’ that is connected to the relay and to...
Forum: Porsche 911 Technical Forum 07-11-2019, 09:26 AM
Replies: 8,105
Views: 934,527
Posted By FrankM_
New leather dashboard top in ! (Original one was...

New leather dashboard top in ! (Original one was warped beyond repair) Almost looks too clean now.


http://forums.pelicanparts.com/uploads26/IMG_19751562865794.jpg
Forum: Porsche 911 Technical Forum 07-10-2019, 11:40 PM
Replies: 9
Views: 777
Posted By FrankM_
I relaced the same line (top one) last year on my...

I relaced the same line (top one) last year on my '85 Carrera and went to my Porsche dealership to ask for the line. They gave me this : N 0203591, it is way too long (as you can see by the...
Forum: Porsche 911 Technical Forum 07-10-2019, 11:13 PM
Replies: 5
Views: 400
Posted By FrankM_
I remember I also used paint stripper on the...

I remember I also used paint stripper on the whole board (backside) and redid all solder connections just to avoid bad contacts. Re-varnished the back side when all testing was done to protect it...
Forum: Porsche 911 Technical Forum 07-09-2019, 11:59 PM
Replies: 5
Views: 400
Posted By FrankM_
Hi, Had the same on my MY85. The fact that your...

Hi,
Had the same on my MY85. The fact that your CC already engages and works the actuator is a good sign.

To fix the surging I replaced 3 capacitors :
2x 47 uF 16V in the middle of the board...
Forum: Porsche 911 Technical Forum 07-05-2019, 09:23 AM
Replies: 39
Views: 996
Posted By FrankM_
Excellent news ! As to the RED/BLU -> BLU,...

Excellent news !

As to the RED/BLU -> BLU, I can only assume that it is in the place the alarm unit would normally be ?
Forum: Porsche 911 Technical Forum 07-04-2019, 10:14 PM
Replies: 39
Views: 996
Posted By FrankM_
OK, the D+ should indeed have a path to...

OK,

the D+ should indeed have a path to ground ( '0V' , I believe through the generator brushes?) if the alternator is not running.
I had to find the schematic for a '86 and it is different...
Forum: Porsche 911 Technical Forum 07-03-2019, 10:27 PM
Replies: 39
Views: 996
Posted By FrankM_
Grounds are checked. Sounds to me like your...

Grounds are checked.
Sounds to me like your alternator light is bad (or the socket it fits into) ?

The electrical path of interest here is : 12V -> ignition switch -> bulb -> D+ (to ground via...
Forum: Porsche 911 Technical Forum 06-20-2019, 11:09 PM
Replies: 10
Views: 845
Posted By FrankM_
Measure your disc thickness, I believe it should...

Measure your disc thickness, I believe it should be 20 mm for a 1972, it changed to 24 mm on the Carrera of 1984 or later. Make sure you are using the right one
Forum: Porsche 911 Technical Forum 06-20-2019, 07:33 AM
Replies: 20
Views: 1,188
Posted By FrankM_
Mine is in treatment at Lakewell.com since I live...

Mine is in treatment at Lakewell.com since I live near them, they have a lot of the original colours on their webshop but you can always call them (Central European Time).
Forum: Porsche 911 Technical Forum 06-17-2019, 03:50 AM
Replies: 9
Views: 509
Posted By FrankM_
This is what I have on the driver's side...

This is what I have on the driver's side headlight. I needed to stop the 'side light' from working. In the end, I made a Y-split so both the front blinker and sidelight are now connected to the...
Forum: Porsche 911 Technical Forum 06-11-2019, 11:04 PM
Replies: 11
Views: 652
Posted By FrankM_
I see you are recharging by weight. I just had...

I see you are recharging by weight. I just had it filled with 950 grams of R134a (approx 80% of R12 weight specified). What is the common agreement on weight of R134a needed for this system ?
Forum: Porsche 911 Technical Forum 06-06-2019, 01:36 AM
Replies: 13
Views: 916
Posted By FrankM_
Mine has 30 mm on the rear (16inch fuchs) and no...

Mine has 30 mm on the rear (16inch fuchs) and no rubbing, none in front.
Forum: Porsche 911 Technical Forum 06-05-2019, 01:41 AM
Replies: 3
Views: 465
Posted By FrankM_
On mine (MY1985) I use a circlip plier to unscrew...

On mine (MY1985) I use a circlip plier to unscrew the top using the two holes.
Forum: Porsche 911 Technical Forum 05-29-2019, 06:43 AM
Replies: 14
Views: 931
Posted By FrankM_
The 'factory manual' you are talking about, are...

The 'factory manual' you are talking about, are that those >1000 EUR binders ?
Forum: Porsche 911 Technical Forum 05-29-2019, 04:31 AM
Replies: 14
Views: 931
Posted By FrankM_
OK, thanks ! I will contact them as they do not...

OK, thanks ! I will contact them as they do not list the 1985 non-turbo on ebay (for int'l delivery).
Forum: Porsche 911 Technical Forum 05-29-2019, 01:54 AM
Replies: 14
Views: 931
Posted By FrankM_
Where can I find a color version of the electrical diagrams?

I sometimes see parts of a color version of an electrical diagram for a 911. Is there a PDF (or large format print) somewhere for an 85 Carrera 3.2 ?

I am using the diagrams in the Bentley manual...
Forum: Porsche 911 Technical Forum 05-27-2019, 06:18 AM
Replies: 67
Views: 3,056
Posted By FrankM_
Good to hear that basic replacement of the dog...

Good to hear that basic replacement of the dog teeth, slider & synchro's can improve it !

I have done too much work (costs) this year to tackle the gearbox, and mostly it works fine (88K miles). ...
Forum: Porsche 911 Technical Forum 05-27-2019, 06:11 AM
Replies: 9
Views: 531
Posted By FrankM_
I do change them every 2 years irrespective of...

I do change them every 2 years irrespective of mileage (doing approx 2K miles/year) since its only a 10 Eur cost per 6 plugs. That's not really adding significant amounts to the running cost.
The...
Forum: Porsche 911 Technical Forum 05-15-2019, 01:29 AM
Replies: 6
Views: 257
Posted By FrankM_
Yep, I know I need the 'upper right' connection...

Yep, I know I need the 'upper right' connection with the 1V simulated narrowband, I am just trying to find out if anybody had already done it and some practical experience before buying this module...
Forum: Porsche 911 Technical Forum 05-14-2019, 05:21 AM
Replies: 6
Views: 257
Posted By FrankM_
Anybody using the narrowband output of a PLXdevices AFR gauge to drive the motronic ?

Hi,

Is anybody using the analog 0-1V output of a PLXdevices (https://www.plxdevices.com/ProductDetails.asp?ProductCode=897346002870) AFR unit to drive the motronic O2 sensor input on a Carrera 3.2...
Showing results 1 to 25 of 47

 
Forum Jump

All times are GMT -8. The time now is 04:35 PM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.