Pelican Parts Forums - Search Results

		Pelican Parts Forums > Search Forums
Search Results

Garage

Page 1 of 3

Showing results 1 to 25 of 70
Search took 0.01 seconds. Search: Posts Made By: mas88s

Forum: 911 / 930 Turbo & Super Charging Forum

04-30-2018, 12:36 PM

Replies: 28

16" Tires

Views: 1,916

Posted By mas88s

Hi Jeff, Do the 225/50"s rub or hit anywhere? ...

Hi Jeff,
Do the 225/50"s rub or hit anywhere?
Thanks, Mark

Forum: 911 / 930 Turbo & Super Charging Forum

07-17-2017, 05:10 AM

Replies: 6

CIS problem

Views: 620

Posted By mas88s

I rebuilt the FD. Watched the videos, read the...

I rebuilt the FD.
Watched the videos, read the directions and took my time.
Just the O rings and diaphragm. Note the diaphragm had multiple pin holes in it.
I put it in open loop (disconnect the...

Forum: 911 / 930 Turbo & Super Charging Forum

07-11-2017, 03:35 AM

Replies: 6

CIS problem

Views: 620

Posted By mas88s

Hi Brian...Thanks for a response Good question....

Hi Brian...Thanks for a response
Good question.
I know the o2 sensor is connected and I know the frequency valve is buzzing and that's about it.
I guess I'll search for a thread....

Forum: 911 / 930 Turbo & Super Charging Forum

07-10-2017, 02:11 PM

Replies: 6

CIS problem

Views: 620

Posted By mas88s

CIS problem

I have been chasing this problem for a while and I need a few suggestions as to how to proceed.
1986 930 K27, Kokeln intercooler rebuilt 8000 miles ago approx 10 years. 58,000mi
Car starts , after...

Forum: 911 / 930 Turbo & Super Charging Forum

06-13-2017, 04:18 AM

Replies: 12

DR Jeckle Mr Hyde

Views: 1,009

Posted By mas88s

Hi Dennis, Did you do the EFI conversion?

Hi Dennis,
Did you do the EFI conversion?

Forum: 911 / 930 Turbo & Super Charging Forum

05-30-2017, 05:16 AM

Replies: 4

EFI conversion

Views: 467

Posted By mas88s

I couldn't agree with you more...I have been...

I couldn't agree with you more...I have been fixing my own vehicles for a long time and I am right on the fence with this project.

Forum: 911 / 930 Turbo & Super Charging Forum

05-29-2017, 05:28 PM

Replies: 4

EFI conversion

Views: 467

Posted By mas88s

EFI conversion

Does anyone know of a reputable shop in the Phila area that does EFI conversions?
Thanks

Forum: 911 / 930 Turbo & Super Charging Forum

05-29-2017, 12:10 PM

Replies: 12

DR Jeckle Mr Hyde

Views: 1,009

Posted By mas88s

OK I decided to replace fuel pumps. There is no...

OK
I decided to replace fuel pumps. There is no change.
Its almost like it clicks lean then rich and so on.
I had it on the lift when it did it and there was no change in the fuel pumps. Both new...

Forum: 911 / 930 Turbo & Super Charging Forum

05-20-2017, 04:34 AM

Replies: 12

DR Jeckle Mr Hyde

Views: 1,009

Posted By mas88s

Thanks for the replies. I'm going after the...

Thanks for the replies.
I'm going after the fuel pumps today.
Got this from the service manual
Gauge between rear fuel pump and supply line under car.
"Read pressure gauge. Pressure must be...

Forum: 911 / 930 Turbo & Super Charging Forum

05-19-2017, 09:12 AM

Replies: 12

DR Jeckle Mr Hyde

Views: 1,009

Posted By mas88s

DR Jeckle Mr Hyde

My car has developed a split personality that I have been trying to track for the last year.
Here goes.
1986 US 930 K27, Kokeln..still cis but leaning heavy towards EFI
cold start afr...

Forum: 911 / 930 Turbo & Super Charging Forum

05-19-2017, 08:57 AM

Replies: 9

no power at WUR and AAR

Views: 604

Posted By mas88s

Socket pin. I didn't think of that. I spread the...

Socket pin. I didn't think of that. I spread the relay pins with a razor knife.
As far as testing I used MM for continuity and test light for 12V.
Thanks again for your help.
Mark

Forum: 911 / 930 Turbo & Super Charging Forum

05-19-2017, 04:08 AM

Replies: 9

no power at WUR and AAR

Views: 604

Posted By mas88s

Hi Guys, Thanks for the reply. I checked all...

Hi Guys,
Thanks for the reply.
I checked all of the above and it was correct.
Went under trunk to rear pump relay relay and wiggled it.
Rpm's went up and down.
China made ...10 months old POS...

Forum: 911 / 930 Turbo & Super Charging Forum

05-18-2017, 04:01 AM

Replies: 9

no power at WUR and AAR

Views: 604

Posted By mas88s

I don't think its the wire because AAR is dead...

I don't think its the wire because AAR is dead also #8

Forum: 911 / 930 Turbo & Super Charging Forum

05-18-2017, 03:58 AM

Replies: 9

no power at WUR and AAR

Views: 604

Posted By mas88s

Hi Brian, I did check , it is pin #10. Is the...

Hi Brian,
I did check , it is pin #10.
Is the connector in the engine bay or under the seat?

Forum: 911 / 930 Turbo & Super Charging Forum

05-17-2017, 12:29 PM

Replies: 9

no power at WUR and AAR

Views: 604

Posted By mas88s

1986 930 us

1986 930 us

Forum: 911 / 930 Turbo & Super Charging Forum

05-17-2017, 12:29 PM

Replies: 9

no power at WUR and AAR

Views: 604

Posted By mas88s

no power at WUR and AAR

This seems a little odd but I have no power at WUR and AAR however rear fuel pump is running and fuses are good.
Any suggestions?
Thanks, Mark

Forum: 911 / 930 Turbo & Super Charging Forum

12-04-2016, 06:03 AM

Replies: 72

Low rpm popping

Views: 3,550

Posted By mas88s

I thought I would have a final post to put this...

I thought I would have a final post to put this issue to bed.
I pulled the WUR, sent it to RarelyL8, reinstalled it. Works perfectly.
Here's the thing.
As I was taking the pressure readings, they...

Forum: Porsche 911 Technical Forum

12-04-2016, 05:48 AM

Replies: 89

Post up your dogs & cars pics here

Views: 8,690

Posted By mas88s

http://forums.pelicanparts.com/uploads26/004148086...

http://forums.pelicanparts.com/uploads26/0041480862837.jpg

Forum: 911 / 930 Turbo & Super Charging Forum

10-05-2016, 09:33 AM

Replies: 72

Low rpm popping

Views: 3,550

Posted By mas88s

OK S*** has hit the fan. AFR's all over the...

OK
S*** has hit the fan.
AFR's all over the place. Car stalls....

For instance,
Cold start AFR's start at 15.5 then work down to 12.5 in about a minute then car goes way lean all the way until...

Forum: 911 / 930 Turbo & Super Charging Forum

10-01-2016, 06:56 AM

Replies: 72

Low rpm popping

Views: 3,550

Posted By mas88s

As I am working thru this car one item at a time...

As I am working thru this car one item at a time I really appreciate your patience and thank you for sharing your knowledge.
That being said .
I can't find the Fudging FV.
It must have been...

Forum: 911 / 930 Turbo & Super Charging Forum

09-30-2016, 08:01 AM

Replies: 72

Low rpm popping

Views: 3,550

Posted By mas88s

Talked to Larry He said take a hard look at the...

Talked to Larry
He said take a hard look at the frequency valve and relay/.
Marco , I have been looking but where is the relay for the FV in a 86 930?
Thanks

Forum: 911 / 930 Turbo & Super Charging Forum

09-30-2016, 07:19 AM

Replies: 72

Low rpm popping

Views: 3,550

Posted By mas88s

I will call Larry...Thank you I did add more...

I will call Larry...Thank you
I did add more fuel and its idling at 10.8 AFR
Still does it :(
Would a bad injector cause this?

Forum: 911 / 930 Turbo & Super Charging Forum

09-29-2016, 05:25 AM

Replies: 72

Low rpm popping

Views: 3,550

Posted By mas88s

Ok the AAR is the auxiliary air valve? The FV...

Ok the AAR is the auxiliary air valve?
The FV ony comes on at boost, if I turn it on inside the car...Andial.
I a not sure if a 86 turbo came with a FV. It does not vibrate at all.
It gets its...

Forum: 911 / 930 Turbo & Super Charging Forum

09-28-2016, 06:15 AM

Replies: 72

Low rpm popping

Views: 3,550

Posted By mas88s

Ok FV valve is Andial and it provides extra...

Ok
FV valve is Andial and it provides extra fuel at boost and it is working properly.
I can watch the afr's drop with each turn of the hobbs dial. So I can eliminate that from the cold start lean...

Forum: 911 / 930 Turbo & Super Charging Forum

09-27-2016, 06:40 AM

Replies: 72

Low rpm popping

Views: 3,550

Posted By mas88s

Sorry I missed that. It does not vibrate. I...

Sorry I missed that.
It does not vibrate.
I replaced the relay and its still dead.
Andial fuel enrichment...
Can it be repaired or should I look for a substitute?
\Thanks

Showing results 1 to 25 of 70

Page 1 of 3

Forum Jump

All times are GMT -8. The time now is 12:48 PM.