Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums


Showing results 1 to 25 of 187
Search took 0.03 seconds.
Search: Posts Made By: Jim75911S
Forum: Porsche 911 Technical Forum 12-29-2011, 05:58 PM
Replies: 7
Views: 1,095
Posted By Jim75911S
On my 75 the passenger side switch ground was...

On my 75 the passenger side switch ground was connected to several other grounds in the trunk. The main ground wire then ran to a terminal block of other grounds connected directly to the dash frame...
Forum: Porsche 911 Technical Forum 12-27-2011, 02:12 PM
Replies: 13
Views: 1,000
Posted By Jim75911S
Throttle body? Rod from gas pedal linkage on one...

Throttle body? Rod from gas pedal linkage on one end and return spring on the other. Just a guess.HTH Jim
Forum: Porsche 911 Technical Forum 12-08-2011, 06:39 PM
Replies: 25
Views: 1,326
Posted By Jim75911S
My 75 has the fuel pump located behind the...

My 75 has the fuel pump located behind the drivers side wheel well. I also had the same problem when attempting to start my rebuilt engine for the first time. The fuel pump sounded air intrained with...
Forum: Porsche 911 Technical Forum 11-26-2011, 08:46 AM
Replies: 12
Views: 877
Posted By Jim75911S
Vw Dealer, I have been told has the fuel line....

Vw Dealer, I have been told has the fuel line. Check manufacturer specs on air brake line, when I did mine I was going to use it but the specs said NOT approved for fuel delivery. HTH
Forum: Porsche 911 Technical Forum 10-19-2011, 06:24 PM
Replies: 2
Views: 286
Posted By Jim75911S
Repost a WTB in the 911 used parts classified.

Repost a WTB in the 911 used parts classified.
Forum: Porsche 911 Technical Forum 10-16-2011, 05:13 PM
Replies: 10
Views: 804
Posted By Jim75911S
I bought the one at NAPA, works great.

I bought the one at NAPA, works great.
Forum: Porsche 911 Technical Forum 10-15-2011, 03:16 PM
Replies: 19
Views: 894
Posted By Jim75911S
Tony, I whole heartly agree with you. Any time...

Tony,
I whole heartly agree with you. Any time I see a CIS post I look for your input. You are an expert as far as I'm concerned. I'm slowly starting to grasp the system via working with another...
Forum: Porsche 911 Technical Forum 10-14-2011, 02:30 PM
Replies: 19
Views: 894
Posted By Jim75911S
CIS, what a nightmare.

CIS, what a nightmare.
Forum: Porsche 911 Technical Forum 10-11-2011, 04:55 PM
Replies: 12
Views: 1,480
Posted By Jim75911S
+1 on Eric Shea.

+1 on Eric Shea.
Forum: Porsche 911 Technical Forum 09-15-2011, 04:05 AM
Replies: 9
Views: 435
Posted By Jim75911S
Appreciate the input, will try all. Jim

Appreciate the input, will try all. Jim
Forum: Porsche 911 Technical Forum 09-14-2011, 04:44 PM
Replies: 9
Views: 435
Posted By Jim75911S
Again, the gauge is pegged even when disconnected...

Again, the gauge is pegged even when disconnected from sending unit on fuel tank, so that elminates the sending unit. Correct? Gauges were rebuilt, wiring connections to gauge checked, at a loss...
Forum: Porsche 911 Technical Forum 09-14-2011, 03:16 PM
Replies: 9
Views: 435
Posted By Jim75911S
Gauge is pegged full whether or not it is...

Gauge is pegged full whether or not it is connected to sending unit, oil gauge is ok.
Forum: Porsche 911 Technical Forum 09-14-2011, 02:57 PM
Replies: 9
Views: 435
Posted By Jim75911S
Fuel Gauge Issue

Fuel gauge is pegged at full if connected to tank gauge or not. Any ideas or previous experience? TIA Jim
Forum: Paint, Bodywork & Detailing Forum 09-13-2011, 05:48 PM
Replies: 9
Views: 2,635
Posted By Jim75911S
Since it is conceled in the rocker panel what...

Since it is conceled in the rocker panel what would it matter? The pipe is the same size as 2"
exhaust tubing. Get some stainless and it will out last the car.
Forum: Porsche 911 Technical Forum 09-13-2011, 01:55 PM
Replies: 11
Views: 1,775
Posted By Jim75911S
Take a sample to your local upolstrey shop and...

Take a sample to your local upolstrey shop and have them match it. If it is a standard color they will have some scrap pieces they might give you. Make a template from the old ones and cut and glue...
Forum: Porsche 911 Technical Forum 09-12-2011, 08:07 PM
Replies: 12
Views: 2,726
Posted By Jim75911S
In my 75, I just mounted the Corbeau seat rails...

In my 75, I just mounted the Corbeau seat rails under the stock mounts. Had to drill a couple holes if I remember but it lowered the seat bottom about 1.5" Plenty of clearence on the sides of the...
Forum: Porsche 911 Technical Forum 09-12-2011, 05:08 PM
Replies: 9
Views: 714
Posted By Jim75911S
To prime the fuel pump on my 75 I jacked up the...

To prime the fuel pump on my 75 I jacked up the front end and disconnected the fuel line on the WUR. Turned ignition on and held a jar under the line, waited to just fuel came thru. Took longer to...
Forum: Porsche 911 Technical Forum 09-11-2011, 02:50 PM
Replies: 1
Views: 255
Posted By Jim75911S
2.7 Engine Dies When In Gear

1975 911S 2.7 Engine dies when put in gear and clutch is released. Will start when cold and rev up but as soon as it is in gear and try to move it the engine dies. Will not start when hot.Where do I...
Forum: 911 Engine Rebuilding Forum 08-14-2011, 12:53 PM
Replies: 4
Views: 785
Posted By Jim75911S
Look in the engine wiring harness that the wire...

Look in the engine wiring harness that the wire shown in the picture comes from. It is possible your oil pressure wire has broken off and is inside the harness. HTH Jim
Forum: Porsche 911 Technical Forum 08-13-2011, 03:49 PM
Replies: 4
Views: 398
Posted By Jim75911S
If those connectors go to the thermo time switch,...

If those connectors go to the thermo time switch, on my car they are two different sizes. If I'm not mistaken the round terminals they connect to, 1 is one diameter and the other a different...
Forum: Porsche 911 Technical Forum 07-14-2011, 03:11 PM
Replies: 5
Views: 866
Posted By Jim75911S
Napa has some strip type sealing material, its...

Napa has some strip type sealing material, its black. 3-M makes it, I call it Dum Dum, I don't recall the correct name. 1/4" in diameter perfect for that application.
Forum: Porsche 911 Technical Forum 07-01-2011, 04:29 PM
Replies: 10
Views: 672
Posted By Jim75911S
Replacing Thermo Time Switch has cured the...

Replacing Thermo Time Switch has cured the problem. This was really a stinker to trouble shoot due to the fact I really did not understand the way the system worked. Now I do. Thanks For All Replies....
Forum: Porsche 911 Technical Forum 06-27-2011, 05:36 PM
Replies: 10
Views: 672
Posted By Jim75911S
Tony, When I connect my test lamp to the...

Tony,
When I connect my test lamp to the plug on the CSV, I get a flash when the starter is first engaged, and I mean just a flash. If I connect 12v to the wire coming off the TTS the...
Forum: Porsche 911 Used Parts For Sale & Wanted 06-26-2011, 02:20 PM
Replies: 2
Views: 214
Posted By Jim75911S
You have a PM

You have a PM
Forum: Porsche 911 Technical Forum 06-26-2011, 01:13 PM
Replies: 10
Views: 672
Posted By Jim75911S
Engine is cold. Air temp 75. Connect test lamp to...

Engine is cold. Air temp 75. Connect test lamp to cold start soleniod power supply, test lamp just flashes 1 time, and I mean flashes for less than a second. Can connect 12v to soleniod and it fires...
Showing results 1 to 25 of 187

 
Forum Jump

All times are GMT -8. The time now is 12:25 AM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.