Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums


Showing results 1 to 25 of 500
Search took 0.12 seconds.
Search: Posts Made By: djnolan
Forum: Porsche 924/944/968 Technical Forum Yesterday, 11:59 AM
Replies: 2
Views: 68
Posted By djnolan
This might be helpful, and would be happy to...

This might be helpful, and would be happy to answer further question.

http://forums.pelicanparts.com/porsche-924-944-968-technical-forum/1005841-camshaft-front-seal.html#post10158030
Forum: Porsche 924/944/968 Technical Forum Yesterday, 03:33 AM
Replies: 11
Views: 258
Posted By djnolan
A door handle can be replaced without removing...

A door handle can be replaced without removing the door card if everything else is ok. Once you have the technique figured out it is a snap or two. Taking the door completely apart will lead to...
Forum: Porsche 924/944/968 Technical Forum 04-06-2020, 09:52 AM
Replies: 11
Views: 258
Posted By djnolan
OK it can be done if you completely take apart...

OK it can be done if you completely take apart the door.

However the small white plastic thing (lock lever - first thing shown in the video) is probably unhooked and as I said above it can be done...
Forum: Porsche 924/944/968 Technical Forum 04-05-2020, 10:19 PM
Replies: 11
Views: 258
Posted By djnolan
It may be as simple as hooking up the plastic...

It may be as simple as hooking up the plastic lock lever. It can be done from the outside easier than taking the whole door apart. Run a piece of fishing line through it so it can be pulled up as...
Forum: Porsche 924/944/968 Technical Forum 04-04-2020, 06:09 AM
Replies: 20
Views: 343
Posted By djnolan
perhaps examining it with an electron...

perhaps examining it with an electron microscope...
Forum: Porsche 924/944/968 Technical Forum 04-03-2020, 04:52 PM
Replies: 20
Views: 343
Posted By djnolan
Maybe to put it in different terms, if the...

Maybe to put it in different terms, if the cylinder was worn out of round, the old ring might seal better than the new one.
Forum: Porsche 924/944/968 Technical Forum 04-03-2020, 03:17 PM
Replies: 20
Views: 343
Posted By djnolan
I one were to compare the rings old and new in...

I one were to compare the rings old and new in the annulus dimension to see if the old ring is worn, and if it is worn, then the new ring might not seal as well as the old ring. Also mark where the...
Forum: Porsche 924/944/968 Technical Forum 04-03-2020, 03:07 PM
Replies: 14
Views: 246
Posted By djnolan
I wish there was something like this to ward off...

I wish there was something like this to ward off tailgaters...
Forum: Porsche 924/944/968 Technical Forum 04-03-2020, 10:36 AM
Replies: 2
Views: 130
Posted By djnolan
Brake sensor related, possibly, there is a brake...

Brake sensor related, possibly, there is a brake module and wiring in this general area on my 87...
Forum: Porsche 924/944/968 Technical Forum 04-03-2020, 10:14 AM
Replies: 14
Views: 246
Posted By djnolan
Compare the ampere rating on the original horn...

Compare the ampere rating on the original horn vs. the air pump. It may be the OEM relay and circuit isn't rated for what the air pump draws. There are relays available for air horns if you search...
Forum: Porsche 924/944/968 Technical Forum 04-02-2020, 02:46 PM
Replies: 7
Views: 266
Posted By djnolan
After having my mechanic replace my original...

After having my mechanic replace my original mounts with Mehle mounts, the car developed an exhaust rattle where the resonator was contacting the underbody tunnel. Sounded like something was going...
Forum: Porsche 924/944/968 Technical Forum 03-31-2020, 02:25 AM
Replies: 16
Views: 443
Posted By djnolan
Call pelican. there must be a lower priced OEM...

Call pelican. there must be a lower priced OEM equivalent not shown. If not check with Lindsey racing.
Forum: Porsche 924/944/968 Technical Forum 03-29-2020, 03:02 AM
Replies: 13
Views: 479
Posted By djnolan
I like to gently get up to about 15 mph in first,...

I like to gently get up to about 15 mph in first, and let the front wheel drive tailgaiters behind me know they are following a classic, then take off in 2nd. The heck with drag racing.
Forum: Porsche 924/944/968 Technical Forum 03-29-2020, 02:59 AM
Replies: 3
Views: 262
Posted By djnolan
The hockey puck's are engine cooling fan...

The hockey puck's are engine cooling fan resistors, and yes maybe some repairs needed.

The factory schematic for the 87 can be found by searching the web for "vol4-electrical.pdf"
Forum: Porsche 924/944/968 Technical Forum 03-28-2020, 02:10 PM
Replies: 13
Views: 479
Posted By djnolan
First. I don't think the drive train was...

First. I don't think the drive train was designed to start off in second. Too much strain on the gears and bearing, also causes more clutch wear.
Forum: Porsche 924/944/968 Technical Forum 03-27-2020, 03:23 PM
Replies: 20
Views: 1,091
Posted By djnolan
And greasable torque tube bearings that you could...

And greasable torque tube bearings that you could Lube from the outside
Forum: Porsche 924/944/968 Technical Forum 03-27-2020, 03:22 PM
Replies: 20
Views: 1,091
Posted By djnolan
This would be something new that I've never seen...

This would be something new that I've never seen some sort of belt tensioner for the drive belts
Forum: Porsche 924/944/968 Technical Forum 03-23-2020, 07:37 AM
Replies: 18
Views: 2,820
Posted By djnolan
The later model wiper motors have a rubber brush...

The later model wiper motors have a rubber brush plate "shock isolation" mounting that needs to be addressed, too. Wish I had a picture to upload.
Forum: Porsche 924/944/968 Technical Forum 03-21-2020, 02:18 PM
Replies: 17
Views: 1,331
Posted By djnolan
The location is 13" forward of the door opening...

The location is 13" forward of the door opening and directly above this is where the battery hold down bracket is. The water may be going under the bracket so I caulked under/around it using 50yr...
Forum: Porsche 924/944/968 Technical Forum 03-21-2020, 02:04 PM
Replies: 26
Views: 1,999
Posted By djnolan
One easy DME test is to check for spark. Pull...

One easy DME test is to check for spark. Pull off the #1 plug wire, hook up an extra plug, and jumper the threads to ground. Give it a crank and see if there is spark. Should be white/blue and not...
Forum: Porsche 924/944/968 Technical Forum 03-21-2020, 12:35 PM
Replies: 18
Views: 2,820
Posted By djnolan
It may be worth posting a picture of the wiper...

It may be worth posting a picture of the wiper motor assembly as not everyone is familiar with the 924S. There is a 944/1 electrical system and a 944/2 (post 85.5 MY) electrical system with...
Forum: Porsche 924/944/968 Technical Forum 03-21-2020, 12:28 PM
Replies: 17
Views: 1,331
Posted By djnolan
I have put three coats of caulk on the leak and...

I have put three coats of caulk on the leak and water keeps washing the caulk away. There most be a pool of water somewhere up above it. Grrrrr...
Forum: Porsche 924/944/968 Technical Forum 03-21-2020, 12:24 PM
Replies: 4
Views: 281
Posted By djnolan
for a schematic google "vol4-electrical.pdf" If...

for a schematic google "vol4-electrical.pdf" If the car has the 944/1 electrical system vs the 944/2 electrics I would just be guessing. However according to the host, the 944/2 relay doesn't fit a...
Forum: Porsche 924/944/968 Technical Forum 03-21-2020, 10:00 AM
Replies: 18
Views: 2,820
Posted By djnolan
Maybe first try some better wiper blades that...

Maybe first try some better wiper blades that don't drag as much and check the ground wire. The one you have could keep working for a long time. No way to tell for sure. But if it quits the new...
Forum: Porsche 924/944/968 Technical Forum 03-21-2020, 07:14 AM
Replies: 18
Views: 2,820
Posted By djnolan
Having been there a couple of times over and over...

Having been there a couple of times over and over I can offer the following:

Buy a used motor and take it to an auto electric place for a refurbish of the brushes and bearings. One item that is...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -8. The time now is 03:32 AM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2020 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.