Pelican Parts
Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   Pelican Parts Forums > Search Forums


Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: smurfbus
Forum: 911 / 930 Turbo & Super Charging Forum 10-15-2018, 08:31 PM
Replies: 3,641
Views: 297,455
Posted By smurfbus
http://forums.pelicanparts.com/uploads26/WP_201810...

http://forums.pelicanparts.com/uploads26/WP_20181015_15_45_41_Pro1539659255.jpg
Forum: Porsche 911 Technical Forum 10-15-2018, 09:18 AM
Replies: 366
Views: 33,736
Posted By smurfbus
http://forums.pelicanparts.com/uploads26/WP_201810...

http://forums.pelicanparts.com/uploads26/WP_20181015_15_46_40_Pro1539620040.jpg


http://forums.pelicanparts.com/uploads26/WP_20181015_14_38_52_Pro1539620090.jpg

...
Forum: Porsche 911 Technical Forum 10-08-2018, 10:49 PM
Replies: 239
Views: 85,233
Posted By smurfbus
I followed the basic instructions IIRC on this...

I followed the basic instructions IIRC on this thread. A longish bolt with washer through the flag base and then file a round slot on the vitaloni bottom side so the base can fit through it and...
Forum: Porsche 911 Technical Forum 10-08-2018, 09:20 PM
Replies: 239
Views: 85,233
Posted By smurfbus
Yup, flag base. Now I have black vitalonis...

Yup, flag base. Now I have black vitalonis installed on the same base.


http://forums.pelicanparts.com/uploads26/IMG_15251539058696.jpg
Forum: 911 / 930 Turbo & Super Charging Forum 10-08-2018, 09:18 PM
Replies: 29
Views: 1,203
Posted By smurfbus
http://forums.pelicanparts.com/porsche-911-technic...

http://forums.pelicanparts.com/porsche-911-technical-forum/955367-resistor-less-rotor-msd-applications.html

I made one myself and it has worked so far.
Forum: 911 / 930 Turbo & Super Charging Forum 10-03-2018, 08:07 AM
Replies: 9
Views: 248
Posted By smurfbus
Do you have a log to show of that second gear...

Do you have a log to show of that second gear 1bar 2nd gear pull? That would be crazy fast spool with gt35r!
Forum: 911 / 930 Turbo & Super Charging Forum 10-02-2018, 10:29 PM
Replies: 9
Views: 248
Posted By smurfbus
Mine is recirculated so no unfiltered air with...

Mine is recirculated so no unfiltered air with loose DV operation. THere has been discussion here earlier that bypassing some air at low revs and vacuum might help the turbo spool.

1 Bar by 3400...
Forum: 911 / 930 Turbo & Super Charging Forum 10-02-2018, 08:25 PM
Replies: 9
Views: 248
Posted By smurfbus
If the boost goes against the piston or diagram...

If the boost goes against the piston or diagram opening it should be ok. I aim for loose spring so it helps the turbo spin out of boost.

I had great success doing a DIY pressure tester installed...
Forum: 911 / 930 Turbo & Super Charging Forum 09-26-2018, 04:19 AM
Replies: 11
Views: 449
Posted By smurfbus
I dont think you want to go smaller than 1mm...

I dont think you want to go smaller than 1mm restrictor. I use 1.5mm but with one holset and its good so far. Have you considered T-ing the drip outlet to sump with a one way valve? I dont think I've...
Forum: 911 / 930 Turbo & Super Charging Forum 09-25-2018, 09:37 PM
Replies: 29
Views: 1,203
Posted By smurfbus
I think even the newer MSD unit will be bigger...

I think even the newer MSD unit will be bigger that your current one. Size L x W x H: 18 cm x 10 cm x 5 cm
Forum: 911 / 930 Turbo & Super Charging Forum 09-24-2018, 09:55 AM
Replies: 21
Views: 1,130
Posted By smurfbus
I run two 38 wgs with no dump pipes at all ( now...

I run two 38 wgs with no dump pipes at all ( now they have pipes for MOT) and the sound is a lot more raw like a machine gun? They point down so maybe the reflections make that sound.

Tim, I...
Forum: 911 / 930 Turbo & Super Charging Forum 09-23-2018, 08:34 PM
Replies: 21
Views: 1,130
Posted By smurfbus
Pic of 6" dump or its not real : )

Pic of 6" dump or its not real : )
Forum: 911 / 930 Turbo & Super Charging Forum 09-22-2018, 01:57 AM
Replies: 10
Views: 516
Posted By smurfbus
This tank has already 415 miles in it. It must be...

This tank has already 415 miles in it. It must be almost done as first gear WOT got some odd taper and jikes the log showed low fuel pressure!!!!

Has anyone istalled a surgetank or what its called...
Forum: 911 / 930 Turbo & Super Charging Forum 09-13-2018, 08:15 PM
Replies: 472
Views: 27,517
Posted By smurfbus
Not sure but if the high current outputs provide...

Not sure but if the high current outputs provide 12V or ground. I used one of the extra injector wires to ground the WMI relay.
Forum: 911 / 930 Turbo & Super Charging Forum 09-11-2018, 09:24 AM
Replies: 10
Views: 516
Posted By smurfbus
I think its doable on steady 50 mph on E85 too...

I think its doable on steady 50 mph on E85 too but steady is not fun. I’ve dialed all vacuum areas to 14.5afr to see if 3d map has any odd spots so it can get better with 15.5 to 16 which runs fine...
Forum: 911 / 930 Turbo & Super Charging Forum 09-11-2018, 04:52 AM
Replies: 10
Views: 516
Posted By smurfbus
Lots of 40-50mph swinging backroads and since the...

Lots of 40-50mph swinging backroads and since the engine pulls really good on fourth even on low revs I usually run in fourth if there are no hills or overtaking. 275/40-17 R888 at the back so no...
Forum: 911 / 930 Turbo & Super Charging Forum 09-10-2018, 11:25 AM
Replies: 10
Views: 516
Posted By smurfbus
342 miles and now I filled the tank

18.23 mpg ~ 12.5 L/100km. Not bad with E85 and tuning with autotune and VEAL so lots of WOT runs too. My earlier good tune went to trash can as I found a torn vacuum line but now its good again and I...
Forum: 911 / 930 Turbo & Super Charging Forum 09-05-2018, 09:02 PM
Replies: 3,641
Views: 297,455
Posted By smurfbus
I'm still on the fence about powder coating the...

I'm still on the fence about powder coating the mirrors the same color. Maybe even some of the interior parts like alu floor boards or the alumin rennline lower dash cover. But that would make...
Forum: 911 / 930 Turbo & Super Charging Forum 09-05-2018, 01:27 PM
Replies: 3,641
Views: 297,455
Posted By smurfbus
Wheels were first sodablasted, then powdercoated...

Wheels were first sodablasted, then powdercoated then the black parts were painted but that alone Was 600eur as the taping was time consuming.
Forum: 911 / 930 Turbo & Super Charging Forum 09-04-2018, 07:51 AM
Replies: 169
Views: 7,727
Posted By smurfbus
http://forums.pelicanparts.com/uploads26/image1536...

http://forums.pelicanparts.com/uploads26/image1536072694.jpg
Forum: 911 / 930 Turbo & Super Charging Forum 09-04-2018, 04:21 AM
Replies: 169
Views: 7,727
Posted By smurfbus
I think on/off is ok for my smallish nozzle just...

I think on/off is ok for my smallish nozzle just to ease my small IC on WOT runs. I get 50C MAT on cruise as my MAT sensor is on the manifold.
Forum: 911 / 930 Turbo & Super Charging Forum 09-03-2018, 11:24 PM
Replies: 3,641
Views: 297,455
Posted By smurfbus
Old look ...

Old look

http://forums.pelicanparts.com/uploads26/Tiedosto_000_3_1536041821.jpg



New look


http://forums.pelicanparts.com/uploads26/IMG_15331536041821.JPG
Forum: 911 / 930 Turbo & Super Charging Forum 09-03-2018, 11:16 PM
Replies: 169
Views: 7,727
Posted By smurfbus
Two weeks later the car has been wonderful. The...

Two weeks later the car has been wonderful. The tune seems to be really good now with EGO OFF at about 17C-25C atmo so hopefully only thing left is to slightly massage MAT correction for colder...
Forum: 911 / 930 Turbo & Super Charging Forum 09-03-2018, 12:55 AM
Replies: 24
Views: 2,253
Posted By smurfbus
I noticed yesteday that my MAT density correction...

I noticed yesteday that my MAT density correction table ’estimated intake temp’ runs 10 celsius over my MAT sensor values? Anyone noticed the same?
Forum: 911 / 930 Turbo & Super Charging Forum 08-31-2018, 04:24 AM
Replies: 226
Views: 55,842
Posted By smurfbus
My refurbished spare has shorter ratios and was...

My refurbished spare has shorter ratios and was too short for my usage so I bought a stock box.

Specs for the short ratio box in the pic (if it shows): It's available if needed.

1st @ 2.25:1 ...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -8. The time now is 02:30 PM.


 
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page
 

DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.