FS: RS project

[jhg41977]

Project has been sold to Shaun84Targa
please contact him for any parets listed below. Thanks!


Body and sheetmetal parts
-Set of nice fenders in good condition, very slight shipping damage to a light box area, easily fixed)
-hood and decklid from original car, so so shape.
-doors from original car, so so shape
-New, not installed or fitted MA Shaw RS bumpers (front and Rear)
-Dashboard top metal (small rust spot in corner of the dash on shell, so I bought this on ebay)
-NOS Fender wings (left and right)
-NOS rockers (inner and outer left and right)
-NOS jack tubes and supports (left and right)
-New Porsche Tank support
-New (cannot verify origination) suspension pan
-71 front clip (needed battery boxes and front lip) bought from ebay
-70? rear clip (bought for tops of quarters, light box surrounds and frame portions) bought from Alex in Connecticut.
-74 factory RS quarters, bought from Mikey74 Pelican
Interior Parts
-380mm steering wheel with button- I would send out for refinish, no leather on it)
-knee pads good on both sides, believe them to be original
-door panel tops, believe them to be original
-Gauges, believe them to be original, also have a few extras (no cool ones)
-aluminum trip for dash, I believe it is all there
-NO Seats, dash or door pockets.
Suspension
-complete stock 72 T suspension. Consider all brakes and sterring rack to be cores
-NOS front control arms with sway bar tabs
-steering rack and column
Driveline
-No original driveline but the 72 oil tank, console (916 part number) and a few oil lines are there
-70? oil tank and console
-69E case, pistons and cylinders, heads, cam towers, chain boxes, oil cooler, intermediate shaft '0', engine cylinder tin
-65 heads (2 damaged from debris in the cylinder), oil cooler, engine cylinder tin
-green shroud
-black shroud
-902/1 transmission internals, no gears no differential, mostly forks etc.
Misc parts
-Nice set of Cibie hood lights with yellow fog parts for inside globe mounting. Lenses are not matched but you cannot tell unless you look at the markings.(bought from camarnott Pelican
-New repro lenses from Rene (as seen on Pelican)
-Nice set of H1s from shaun84targa Pelican
-NOS Hells 4400 mirror black finish, ebay
-Maunal trans brake/clutch pedal, Pelican, unsure who, supposed to be rebuiilt
-Rear light housings, ebay sos so shape, was going to use as mock up pieces
-two wiring harnesses, one from car cut at back of tunnel, one from a Pelican
-heating ducts, boxes etc from original car
-heater flapper box things that go in the engine compartment, ebay, nice shape
-two large boxes of mis stuff from dismantling of the original car.

[jhg41977]

I could deliver in the New England Area, possibly beyond, but not too far.

[carcfo]

I am interested in the front fenders which you have described as good. Please provide a price and more details offline re extent of damage and rust to geraldmccormick@mindspring.com or 601-918-7949.
GWM

[porsche735]

I could use the '71 front clip and suspension pan. How much you want for those? I am located in CA.

Chris

[jhg41977]

The front clip was purchased for the battery boxes and front lip. The clip has had previous, poor quality work done to the suspension pan/tank support area and I would not consider using the clip as is. For parts certainly ok. I will begin to split parts up on Sunday if I do not get an offer that is near my asking price for the entire project.

PM sent to porsche735 regarding clip and pan

[jbell959]

I'm interested in knee pads, aluminum dash trim, and rs door panels if you decide to split it up.

[DCOP]

jhg...I live about 20 miles north of Concord. I would like to stop by and look at some of your parts. Are you going to be around this Saturday (6/14)? You can e-mail me if you wish. dcoplan@conknet.com. Thanks Darryl

[jhg41977]

I will be around. Email sent

[jhg41977]

Bump

[XTN901]

cibies
email christancourtney@prodigy.net.mx

[jhg41977]

I believe this is sold as a complete project. I will know for sure on Tuesday when he comes to look at it. Thanks
Jim

[jhg41977]

Project has been sold complete. Please contact Shaun84Targa if there are parts you are interested in. Thanks!

[jhg41977]

Project has been sold complete. Please contact Shaun84Targa if there are parts you are interested in. Thanks!