FS: ROW 3.0;Oil Lines&Cooler;915 Trans;

19-911-65 · 01:26 AM

Parting out a VERY RUSTY early '73 #9113500042 that has been sitting for about 5 years

1) Engine: -SOLD-
# 6304153 ; 1980 ROW 911SC 3.0 TYPE 930.09, runs

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=007&sspagename=STRK%3AMESE%3AIT&viewitem=&item=170097795122&rd=1&rd=1

Cylinder___Compression______Leak down

__1__________150_____________12%
__2__________148_____________10%
__3__________151______________8%
__4__________150_____________11%
__5__________151______________8%
__6__________160_____________11%

2) 915 5 speed trans- SOLD-
See picture below- It is a 915/62 '80sc 915 aluminum. trans. 8:31 ring and pinions; Bell house # 915.301.101 7R; center section # 915.301.102 3R, end casting # 901.301.301 6R. Bottom boss ????30 1773, electric tack, helper spring on shift arm.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=007&sspagename=STRK%3AMESE%3AIT&viewitem=&item=170097810391&rd=1&rd=1

3) Front Fender Oil Cooler and lines- '74 and up (t-stat is in front of pass. rear tire, hard lines run along side the pass. rocker, NOT in the rocker) Cooler is sold, still have the lines

4) Oil Tank

5) Fuel Tank

6) Short Hood

7) 915 Shifter -SOLD-

8) Alum. Trailing Arms, hubs...complete

9) Steering Wheel

10) Dash switches- Cig lighter- sold

11) Tub with title (and it is a RUST BUCKET!!) must pick-up, no delivery

12) Starter- used good condition- 25.00 plus shipping

13) Most anything else you see other than the front suspension

I can ship this out most anyway you like at cost to you. I am also going to Hershey next month with a stop over in Richmond and can deliver the big stuff to you (close to 95 north)

If interested email me with your questions and offer.

email: 37northstar@msn.com

Thanks,

Glenn

euro911sc · euro911sc's Garage

How much for the AL shift tower only?

Best regards,

Michael

19-911-65 · 03-28-2007, 08:42 PM

Quote:

Originally posted by euro911sc
How much for the AL shift tower only?

Best regards,

Michael

Hi Michael,

Please send me an email so I can reply back to you......My "OLD-TIMERS" will never let me keep this straight with out my email log...;-)

Thanks again,

Glenn

email: 37northstar@msn.com

retireduper · 03-29-2007, 03:29 AM

How much for the cigarette lighter, and if it is around $10 I will take it.
Thanks
Chuck

PaulD · 03-29-2007, 09:35 AM

PM sent on the oil cooler

19-911-65 · 03-29-2007, 11:47 AM

Quote:

Originally posted by retireduper
How much for the cigarette lighter, and if it is around $10 I will take it.
Thanks
Chuck

Hi Chuck,

That will be fine. Let me take it out and make sure it works for you. I will post later today.

Regards,

Glenn

19-911-65 · 03-30-2007, 09:05 PM

Quote:

Originally posted by 19-911-65
Hi Chuck,

That will be fine. Let me take it out and make sure it works for you. I will post later today.

Regards,

Glenn

Chuck,

I removed the lighter and tested it...it gets hot but the lighter "button?" does not glow red....

Let me know if you would still like it

Glenn

retireduper · 03-31-2007, 03:07 AM

Glen,
The element is probably going, but I will take it if you will settle for 8 plus shipping. If that works send me an invoice , or link to your PayPal account, and I will pay it, and send you an address to mail it to here in Florida. You can reach me at cjyedinak@msn.com.
Thanks
Chuck

19-911-65 · 03-31-2007, 03:15 AM

Quote:

Originally posted by retireduper
Glen,
The element is probably going, but I will take it if you will settle for 8 plus shipping. If that works send me an invoice , or link to your PayPal account, and I will pay it, and send you an address to mail it to here in Florida. You can reach me at cjyedinak@msn.com.
Thanks
Chuck

Will do..... Thanks Chuck!

Glenn

GBStu · 03-31-2007, 09:13 AM

Glenn,
How about $20 for the fog light and rear defogger switches?
THanks, Stu

19-911-65 · 03-31-2007, 10:04 AM

Quote:

Originally posted by GBStu
Glenn,
How about $20 for the fog light and rear defogger switches?
THanks, Stu

Hi Stu,

Sure...that will be fine. Please email me so I can get your shipping info and set up payment.

Regards,

Glenn

email: 37northstar@msn.com

jv911 · 03-31-2007, 11:08 AM

PM Sent

C-Pierce · 03-31-2007, 06:51 PM

Steering wheel?

thanks

19-911-65 · 03-31-2007, 09:01 PM

Quote:

Originally posted by C-Pierce
Steering wheel?

thanks

Still have it, needs recovering...make me an offer...

Thanks,

Glenn

email: 37northstar@msn.com

19-911-65 · 11:09 PM

Transmission:
I feel it is a 915/62 '80sc 915 aluminum. trans. 8:31 ring and pinions; Bell house # 915.301.101 7R; center section # 915.301.102 3R, end casting # 901.301.301 6R. Bottom boss ????30 1773, electric tack, helper spring on shift arm.

I never ran it but PO said it ran/shifted fine.