Some motor dimensions needed
 

Hi folks, I need some motor dimensions if anyone has them. The length of the motor for a 3.0 and 3.6, measured from the front most face of the bellhousing flange to the snout of the crank. Rough approximate is just fine, even total length of just the case itself would work just fine :) Also approximate width of motor measured at it's widest point(VC to VC along cam housing centerline?)

I'm trying to see relatively how dimensionally close this non-Porsche 3.3L flat six is to the 3.0/3,6 motors.

Thanks in advance..

Adam, I've got both a 3.0 and 3.6 bare case. 3.0 measures 20 1/2 and the 3.6 20 5/8" long. Don't have an assembled motor at the moment for the other dimension.

Hey thanks very much for that info! It gives me a good idea on how big this motor is in comparison to those Porsche engines for rough fitment clearances in my kit car.

Thanks again!

-Adam