|
|
|
|
| Author |
|
|
Registered
Join Date: Mar 2022
Posts: 12
|
911sc 3.0 intermediate shaft runout question
I can’t find a spec for the runout on the intermediate shaft. I currently have about .002 runout and it doesn’t bind but I also only have it sitting in the case. My concern is when I close the case and about future wear and potential vibration. Any input is appreciated.
|
||
02-14-2023, 07:06 PM
|
|
|
Registered
Join Date: Oct 2008
Location: Nash County, NC.
Posts: 8,467
|
If you recall the IS bearings were worn to the top being pulled up by the chains and tensioners..
.002 isn’t going to change that, or cause a problem. Bruce |
||
|
02-15-2023, 07:15 AM
|
|
|
Registered
|
This may help
__________________
Roland 930 Turbo '81 Too many modifications to list |
||
|
02-16-2023, 05:32 AM
|
|
