x-faktory...3.4 testing
 

I was contacted a few months ago by a local Porsche nut, who asked if I would test his newly built 3.4 engine. This was his 1st 911 engine build and he wanted his engine run-in on my test stand, tuned etc. Nice 3.4 build with PMO/EFI and AEM Infinity controller kit. I ran the engine in and then started tuning.....needs a little more fine-tuning, but this one runs very well!.......I have to say......wow! great job on your 1st build Franco!!!!!!
https://www.youtube.com/watch?v=qV7nLDojmJg


regards,
al

http://forums.pelicanparts.com/uploa...1570857928.JPG
http://forums.pelicanparts.com/uploa...1570857928.JPG
http://forums.pelicanparts.com/uploa...1570857928.JPG

done....well done
 

Finished testing Franko's 3.4 engine this morning....runs great and the leakdown numbers were also great....4% on 1,3,4,5,6 and 5% on # 2.......Once again, congratulations on your 1st Porsche engine build.

<iframe width="961" height="721" src="https://www.youtube.com/embed/Slj0XvpyuFQ" frameborder="0" allow="accelerometer; autoplay; encrypted-media; gyroscope; picture-in-picture" allowfullscreen></iframe>

Hi Al
I wanted to say this hundred times ..There no way I could have done this motor to start and tuned without your help...I am very please The X-factory Co. their Top quality experience workmanship..
Thank you -Franko-

Nice! There's a set of my squirters in there!

Hey Catorce
Yes Of course ..Never have to worries about replacing old squirter next rebuilt
Thanks