Anyone know the off set of 17" Cup 1 wheels (Italian replica)

[Johnny B]

Hello,

Any know the off set on these 17" Cup 1 wheels (Italian replicas) I am not sure how to measure off set and was told it was a bit tricky.

Thought someone may have the information on hand, see photos below. I have a friend who wants to buy them to fit on a 964 and thinks they may not work.

All advice and suggestions appreciated. Thanks for all the help.

[sc_rufctr]

Looking at the last photo they look like the correct offset for an SC or 3.2.
The "Cups" for 964's don't have that protruding centre section. (not as much anyway)

They could be machined down to 964 spec easy enough but that depends on the lug hole depth.

[sc_rufctr]

This will help... http://forums.pelicanparts.com/porsche-964-993-technical-forum/399143-964-vs-993-systems-analysis-3.html

[Johnny B]

thanks a lot

[sc_rufctr]

Can you seen any part numbers on the back?

[Geronimo '74]

Don't put your wheels facing down on the concrete like that, unless you like scratches...

[Wavey]

They should be marked for ET somewhere on the front or back. Those replicas were made in 2 versions for both pre-89 and 964 fitments. He needs something like ET55.

[Johnny B]

thanks everyone much appreicated