|
|
|
|
| Author |
|
|
Registered
Join Date: Oct 2002
Location: Orlando
Posts: 629
|
Carrera rear valence hardware
Ok putting my bumper pieces back together after many months on my 1989 Targa Carrera...and can't find the hardware that attached the rear valence to the bottom of the bumper. There is a rubber seal that goes in between the valence and the bumper. Anyone have a picture of what these screws look like? It is #4 in the diagram. Dont remember if they are phillips head...Here is the part number 90027802409 M6x10.
__________________
08 Cayenne V6 89 911 Targa Carrera 3.2 75 914-6 Conversion Last edited by bcheney; 09-06-2014 at 02:14 PM.. |
||
09-06-2014, 02:10 PM
|
|
|
Rescuer of old cars
|
Mine are large phillips head. No pictures, I'm not near the car right now.
__________________
2018 718 Cayman 2.0 Priors - '72 911T coupe, '84 911 Carrera coupe, '84 944, '73 914 2.0 |
||
|
09-06-2014, 04:18 PM
|
|
|
vince_wa
|
Mine were large head Phillips - I replaced them with stainless bolts (less problem with dirt in head)
__________________
Garage - 1987 911 widebody |
||
|
09-06-2014, 04:36 PM
|
|
|
Immature Member
|
Ditto, replaced mine with stubby little hex bolts. I had to drill some of the old corroded Phillips head OE bolts out. Next time will be a breeze with proper bolts, like say if (when) I have to do another engine drop.
__________________
1984 Carrera Coupe = love affair 1997 Eagle Talon Tsi = old girlfriend (RIP) 2014 Chrysler 300 AWD Hemi = family car "Lowering the bar with every post!" |
||
|
09-06-2014, 05:02 PM
|
|
'84 Carrera Coupe (Sold)
The Yellow One (Sold)
The one I wanted for decades (Sold)
Cayman
911 Targa Supersport
1984 Porsche Carrera
Eagle Talon TSi AWD
Chrysler 300 AWD Hemi
