Reelectroplating factory cylinders
 

Does any one have any experience with recoating factory cylinders? I saw an ad for a race car and in the description they talked about recoating done by LN

Thanks

David

When we did my 72E 2.4, we had the cylinders bored from 84mm to 85mm and replated to use JE pistons.

They were done by this place, we were very satisfied with their work and they're working great in the car.

PowerSeal USA

Millennium technologies.

They actually do it. No middle man.

Airplanes Porsches ATVs etc etc etc

Don't waste your time elsewhere

Cylinder Services | Millennium Technologies

+1 Milliennium Technologies.

How much did they charge you? I can't find any prices on line

Thanks

David

it looks like there are estimates right on the MT website.

I got a set from EBS Racing on an exchange basis, but Millennium Technologies actually does it for them, I think.

2012 Price to bore and replate Nikasil 3.6L to 3.8L was about $900 from EBS
And about $900 for the 12.5:1 CR JE pistons . . .

When we did an engine refresh at 60 racing hours the cylinders still had the cross hatching - new rings and bearings and good to go . . .

Regards,
http://forums.pelicanparts.com/uploa...1526174148.jpg