Feeler - Fuel Lines for 3.2L, Stainless & Teflon

[Mason_paul]

Thanks for the kind words Mark!

[tmaull]

Interested. The adapters go from AN to DIN?

[Mason_paul]

Some of the attachments I’ve developed straight metric fittings for, where clearances were especially tight. There are a couple places where there’s plenty of room for a metric to AN adapter so I go that route.

[Mason_paul]

Mid spring bump

[Mason_paul]

Independence Day bump
I can’t edit the thread title to add the price but they’re currently $440 + $15 shipping.
Thanks!
Paul
mason_paul@yahoo.com

[Mason_paul]

Bump!

[Boydyrs]

Paul can you provide price for full kit pls? Will this fit a 964 3.6 also? Raymond

[Mason_paul]

Hi Raymond; the 3.2 kit is $440 + $15 S&H, and it does not fit a 964. I do make one of those kits too; they're $495 + $15 S&H. I'll PM you also.

[Mason_paul]

It’s-almost-Fall bump!

[Mason_paul]

Trick or treat bump! I’m going to start keeping these in stock as a couple folks have asked me to have some around for drop shipping...so order times should drop a bit.

Thanks!

[Mason_paul]

2 on the shelf

Let me know if you need one.

[luftgekuehlt911]

Hello Paul.. I'm interested in buying a kit from you could you send me a PM?

Thanks in advance

[Mason_paul]

PM sent!

[RandyA]

Hello Paul, I am in need of a set of fuel lines for my 1988 cabriolet. The back line between the regulator and the damper has a tiny leak. So small that it only would leak occasionally. It only took me an month and a half to find it! I would like to get a whole set and replace them all at the same time. Please send me a PM so that we can connect.
Thanks!
R

[Mason_paul]

Hey, I sent you an email, PM was not available? You can always email me at mason_paul@yahoo.com

[tadink]

Paul is great to work with, highly recommend.....
tom
napa