FS aluminum pressure plate

[Flat6pac]

No longer available as incorrect post.
Regrets,
Bruce

Good used, just the plate, no TOB
$120 PayPal, shipped, tracked
Thanks

[rgupta250]

Bruce,
If this fits my 71 Porsche 911 then I’ll take it. I have sent you a PM.

Thanks,
Ravi

[stownsen914]

It's a heavier spring than what came on the 70-71 cars, but it will bolt right up. I have used that exact setup.

When you have the trans out, check the TO fork pivot pin. They're known to pull out or break on the 70/71 trannies. If it looks good, red loctite it.

[Shaun @ Tru6]

Originally Posted by stownsen914

It's a heavier spring than what came on the 70-71 cars, but it will bolt right up. I have used that exact setup.

When you have the trans out, check the TO fork pivot pin. They're known to pull out or break on the 70/71 trannies. If it looks good, red loctite it.

great information!

[gled49]

Is the PP a 225mm or 240mm. Would you please measure, the shape of the diaphragm fingers doesn’t look like 911 or 915.

[john walker's workshop]

Big hole, 930 perhaps?

[stownsen914]

Whoops, it does look like it says 240 on it, not 225.

Rgupta250 - in which it would not fit your 71. Apols for the the earlier incorrect information.

[rgupta250]

Thank you for all the responses. I will need to pass on this aluminum pressure plate.

GLWS Bruce!

[Flat6pac]

Thanks for getting this right
Bruce