3.8 RSR Induction system
 

This is a complete intake/plenum/throttles for a 3.6/3.8 911 eng.
it has 50mm ind. throttles with the large single plenum valve, it was setup for Motec on an RSR the system was bought new from Europe and has around 20 hrs. total,it has fuel rails (no inj.) linkage,2 types of inlets, it also has the regulator in the rail for system press. it has a dual bolt pattern for the intake port to fit stock 3.6 or factory 3.8 RSR heads. asking 7500.00
Mike Bruns

Mike,
Id be interested in seeing a pic. What do you mean by "large single plenum valve"?

Not a buyer - just curious,
SMD

plenum valves
 

they have a large throttle type valve in each side of the plenum that around 4000-5000 rpm they open to effectivly lengthen the manifold runners for upper end power,which the valves are controled by the engine management systems, I will take some pics soon and send to you
Mike

I might be interested. I am planning to upgrade my 3.6 to Motec with ITBs. Looking at different alternatives....

To be honest at $7,500 this seems a little steep.
Do you have pictures?

Induction
 

Matteo, send me an e mail address and I will send some pics, this system was expensive new, we are including the TPS and a custom mount for it, the MAP sensor, both fuel rails with the cross over hose, the hi press regulator in the rail which didnt come with it. this system has maybe 20 hrs. total,and was run with a Motec M800
Mike Bruns JBRacing.com

Mike

I know these systems are very expensive. I am looking at different alternatives (Jenvey or TWM ITBs and others) that are a little bit cheaper.
I am still in the planning stages...
I'd run this with a Motec M600. I am also looking at DTA.

I can edit the previous message if you think the wording is misleading

My email address is matteo.amoroso@assiduous.net

induction
 

Bump

Mike

I am goint to have to pass as this set up would be too extreme for my street application.

Thank you very much

Good luck

Matteo